User's Manual

ManualsBrandsKAB ManualsElectronicsRemote Controller

IMPORTANT SAFEGUARDS

WARNING-- To reduce the risk of fire, electric shock, or

serious personal injury

• Do not immerse the product in liquids

• Do not use an electrical device or appliance with this

product whose electrical specifications exceed those

specified in the “Electrical Specifications” section of this

manual.

• For Indoor use.

• Direct plug-in, Operating control.

• Temperature limits of the SWITCH HEAD: 0~40

CAUTION-- To reduce the risk of personal injury or product/

property damage:

• This product is intended for non-commercial, non-industrial

use in the remote control of two electrical outlets.

Do not use this product for any other purpose.

Replacing the battery

• Remove the Battery compartment cover from the back of

the remote control.

• Remove the spent battery and place a new Type CR2032

battery into the Battery Compartment correctly observing

the polarity indications (+/-) inside the Battery Compartment.

• Replace the Battery Compartment Cover.

• Clear the battery contacts and also those of the device prior

to battery installation

Indoor Remote Controlled Countdown Timer

When using electrical products, always follow basic

safety precautions including the following:

Made in China

SAVE THESE INSTRUCTIONS!

RECEIVER MODEL: TM-121

TRANSMITTER MODEL: TR-031-6S

FCC ID: PAGTR-031-6S

IC: 4494A-TR0316S

NOTE: These are general definitions only; all may not pertain to the actual product purchased.

DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in

death or serious injury. Usage of this signal word is limited to the most extreme situations.

WARNING: Indicates potentially hazardous situation, which, if not avoided, may result in

minor / moderate injury or product/ property damage. It also alerts against unsafe practices.

CAUTION: Indicates a potentially hazardous situation, which, if not avoided, may result in

minor/moderate injury or product/ property damage. It also alerts against unsafe practices.

Replacing the battery

ELECTRICAL RATINGS

Features:

• Control electrical outlet up to a distance of 100 feet.

• Has two grounded receptacles.

• Weather resistant housing protects connected lighting.

• Countdown function automatically turns power off 30 min, 60 min, 2 Hr, 4Hr later.

Federal Communications Commission

Interference Statement

This equipment has been tested and found to comply with the limits for Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the interference by one

or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

Federal Communications Commission

Interference Statement

This equipment has been tested and found to comply with the limits for Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the interference by one

or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

FCC Caution: FCC Caution:

The Grantee is not responsible for any changes or modifications not expressly approved by the

party responsible for compliance. such modifications could void the user's authority to operate

the equipment.

Industry Canada statement:.

This device complies with Industry Canada license-exempt RSS standard(s). Operation is

subject to the following two conditions: (1) this device may not cause interference, and (2)

this device must accept any interference, including interference that may cause undesired

operation of the device.

Déclaration d’Industrie Canada:

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio

exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne

doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage

radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

Installation

1. Plug the Receiver into a standard 125-volt AC electrical outlet.

2. Confirm that the electrical specifications of an item you wish to use with this product do not

exceed those specified in the “Electrical Specifications” section. Plug the item into an outlet of

the Receiver.

3. Remove the plastic battery tab from the Battery Compartment in the back of the Remote

Control to activate the 3V pre-installed battery.

Operating Instructions

Control by transmitter:

1. Press the ON button on the transmitter to turn the receiver ON.

2. Press OFF button on the transmitter to turn the receiver OFF.

3. Press 30 min, 60 min, 2 Hr, 4Hr, to turn the receiver on and off after that specific min or hour.

Battery Handling and Usage

WARNING: Keep batteries away from children and pets.

• Follow the battery manufacturer’s safety and usage instructions.

• Insert the battery observing the proper polarity (+/-) as indicated inside the Battery

Compartment.

• Remote a spent or discharged battery from the product. remove the battery when not using

the product for an extended period.

• Never throw batteries into a fire. Do not expose batteries to fire or other heat sources.

• Battery contains mercury. Do not put in trash. Recycle or manage as hazardous waste.

• Dispose or recycle spent / discharged batteries in compliance with all applicable laws. For

detailed information contact your local solid waste authority.

CAUTION: Failure to properly align the battery polarity can cause personal injury and/or

property damage.

Min

2Hr 4Hr

Receiver

Transmitter

Button Layout

1. Operating Mode:

Timer will turn ON, 30 min, 60 min,

2 Hr, 4Hr.

2. Select button:

To select the function and repeatedly.

Power ON 30 min 60 min 2 Hr

4Hr OFF ON

3. Outlets:

Plug the lights or devices to be

controlled by the timer into one of the

outlets.

4. Transmitter

Control by receiver:

1. Press the button. The power indicator will light and the two outlets are “ON”.

2. Press the button and select 30 min, 60 min, 2 Hr, 4Hr, to turn the receiver on and off

after that specific min or hour.

3. Continue pressing the button until all indicator lights are out. All two outlets are turned off.

* Maximum combined wattage for items using a tungsten bulb plugged into the Receiver is

1000W.

* 500 VA Electronic Ballast, 120 Vac, 60Hz, 8.3 A Ballast.

Voltage Frequency Wattage Amperage Horse Power

1000W Tungsten60Hz125VAC 15A 1/2HP

Unique Identifier :

KAB Model No. : TM-121/TR-031-6S

Responsible Party - U.S. Contact Information

Company Name :

Customer Address :

Tel/Internet Contact :

TR-031-6S Remote Controller User Manual