User's Manual

Operating Instructions
FOR OUTDOOR USE
NOTE: These are general definitions only; all may not pertain to
the actual product purchased.
DANGER: Indicates an imminently hazardous situation which,
if not avoided, will result in death or serious injury. Usage of this
signal word is limited to the most extreme situations.
WARNING: Indicates potentially hazardous situation, which, if
not avoided, may result in minor / moderate injury or product/
property damage. It also alerts against unsafe practices.
When using electrical products, always follow basic safety
precautions including the following:
IMPORTANT SAFEGUARDS
WARNING-- To reduce the risk of fire, electric shock, or
serious personal injury
• Do not immerse the product in liquids
• This product is not intended for use by children and
contains small parts that may pose a choking hazard to
children under the age of three. Keep the product out of
the reach of children and pets.
• Do not use an electrical device or appliance with this
product whose electrical specifications exceed those
specified in the “Electrical Specifications” section of this
manual.
CAUTION-- To reduce the risk of personal injury or product/
property damage:
• This product is intended for non-commercial, non-industrial
use in the remote control of two electrical outlets. Do not
use this product for any other purpose.
WARNING: This product is equipped with a
three-prong grounding pin plug to reduce the risk of
electric shock. This plug will fit into a grounded outlet
only one way. This is a safety feature. Never use the
plug with an extension cord unless you can fully insert the
plug into the extension cord. Do not alter the plug. Do not
attempt to defeat the safety purpose of the grounding plug.
3-Outlet Outdoor Countdown
Power Center with Remote Control
Federal Communications Commission Interference
Statement
This equipment has been tested and found to comply with the
limits for Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and the
receiver.
● Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
● Consult the dealer or an experienced radio/TV technician
for help."
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation
of the device.
FCC Caution: Any changes or modifications not expressly
approved by the party responsible for compliance could void
the user's authority to operate this equipment.
1
2 3
4 5
6
Voltage Frequency Electronic Ballast Tungsten Amperage Horse Power
125VAC 60Hz 500VA 1000W 15A 1/2HP
Electrical Specifications
Features
• Control electrical outlet up to a distance of 80 feet.
• Has three grounded receptacles.
• Weather resistant housing protects connected lighting.
• Countdown function automatically turns power off 2,4,6,8
hours later.
INSTALLATION
1. Mount or hang the RECEIVER on the wall near a wall
grounded electrical 125V 60Hz outlet which the power supply
cord of the RECEIVER will plug in to.
2. Plug the cord of the device you wish to control remotely
at the bottom of the RECEIVER.
3. The heat dissipation hole of the bottom must be mounted
close to the wall.
4. The device must be mounted in an altitude that the heat
dissipation openings at the bottom enclosure shall be mounted
close to the wall and in a vertical position with the
receptacle facing downward and with the receptacles at least
2 feet (610 mm) above the ground level, NOT for water
immersion.
5. While the receiver is set to REPEAT ON and at the desired
hours 2 Hr, 4Hr, 6Hr or 8 Hr, press the REPEAT OFF button
to stop the repeating function. This means that the receiver
will finish the set hours and not repeat automatically.
Control by receiver:
1. Press the green button. The power indicator will light and the
three outlets are “ON”.
2. Press the green button and select 2 Hr, 4Hr, 6Hr, 8Hr, to turn
the receiver on and off after that specific hour.
3. Press the green button until the repeat indicator light is on
and this will repeat the same program after 24hrs, daily
repeat.
4. When the repeat light is not on the timer, program will run one
24 hour cycle and turn off.
5. Continue pressing the green button until all indicator lights
are out. All three outlets are turned off.
Button Layout
RECEIVER MODEL #RC-021
TRANSMITTER MODEL #TR-020N
FCC ID: PAGTR-020N
Battery Handling and Usage
WARNING: Keep batteries away from children and pets.
• Follow the battery manufacturer’s safety and usage
instructions.
• Insert the battery observing the proper polarity (+/-) as
indicated inside Battery Compartment.
• Remove a spent or discharged battery from the product.
Remove the battery when not using the product for an
extended period.
• Never throw batteries into a fire. Do not expose batteries to fire
or other heat sources.
• Dispose or recycle spent / discharged batteries in compliance
with all applicable laws. For detailed information contact your
local solid waste authority.
• Battery contains mercury. Do not put in trash. Recycle or
manage as hazardous waste.
Battery Replacement:
1. Remove the Battery Compartment Cover from the back of the
Remote Control by sliding the Cover in the direction that its
trends curve.
2. Remove the spent battery and place a new DC 12V Type A23
battery into the Battery Compartment correctly observing the
polarity indications (+/-) inside the Battery Compartment.
3. Replace the Battery Compartment Cover.
OPERATION
Control by transmitter:
1. Press the ON button on the transmitter to turn the receiver
ON.
2. Press OFF button on the transmitter to turn the receiver OFF.
3. Press 2 Hr, 4Hr, 6Hr, 8Hr, to turn the receiver on and off
after that specific hour.
4. Press REPEAT ON button and set the desired hours 2Hr, 4Hr,
6Hr or 8Hr to have the receiver turn off and repeat the same
program after 24hrs, daily repeat.
OFFON
2Hr
4Hr
6Hr
8Hr
REPEAT
ON
REPEAT
OFF
2Hrs 4Hrs
6Hrs 8Hrs
POWER REPEAT
195mm W x 100mm H
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
Made in China