User's Manual

TO USE
1.To set up the receiver (outlet) with
connecting device.
2. Removes the plastic battery tab from the
battery compartment in the back of the remote
control to active the DC 12V Type A23
pre-installed battery.
3. To activate Receiver, press Upper position of
the transmitter. The red LED of the Receiver
will illuminate.
4. To turn the Receive OFF, press Down position
of the transmitter. The red LED of the Receiver
will shut off.
5. Choose a location on the wall to insert a nail or
wood screw (not included) for mounting the
remote control.
6. Insert the nail /screw into the wall in the
chosen location. The nail or screw head must
extend at least 3/16" from the wall.
7. Hang the keyhole of the transmitter on the nail
or screw.