User's Manual

ManualsBrandsKab ManualsElectronicsRemote Controller

RC-018 + TR-016 Indoor Wireless Remote Control

SET UP

1. Plug the receiver into a standard 125-volt AC electrical outlet.

2. Confirm that the electrical specifications of an item you wish to use with this

product do not exceed those specified in the "Electrical Ratings" section. Plug

the item into an outlet of the receiver.

Summary of content (4 pages)

PAGE 1
RC-018 + TR-016 Indoor Wireless Remote Control SET UP 1. 2. Plug the receiver into a standard 125-volt AC electrical outlet. Confirm that the electrical specifications of an item you wish to use with this product do not exceed those specified in the "Electrical Ratings" section. Plug the item into an outlet of the receiver.
PAGE 2
3. Remove the plastic battery tab from the battery compartment in the back of the remote control to activate the DC 12V Type A23 pre-installed battery. ELECTRICAL RATINGS Range Up to 50ft. 125Vac 60Hz 15 A General Purpose 125Vac 60Hz 15 A Resistive 1,000 W Tungsten 500 VA Electronic Ballast 120Vac 60Hz 8.3A Ballast. 1/2 HP TO USE 1. 2. 3. 4. 5. To set up the receiver (outlet) with connecting device.
PAGE 3
• Remove a spent or discharged battery from the product. Remove the battery • when not using the product for an extended period. Never throw batteries into a fire. Do not expose batteries to fire or other heat sources. • Battery contains mercury. Do not put in trash. Recycle or manage as hazardous waste. Battery Replacement • Remove the Battery compartment cover from the back of the remote control by • sliding the cover in the direction that its treads curve.
PAGE 4
• • Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the • receiver is connected. Consult the dealer or an experienced radio/TV technician for help. • FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. • This device complies with Part 15 of the FCC Rules.