User's Manual

NOTE: These are general definitions only; all may not pertain to
the actual product purchased.
DANGER: Indicates an imminently hazardous situation which,
if not avoided, will result in death or serious injury. Usage of this
signal word is limited to the most extreme situations.
WARNING: Indicates potentially hazardous situation, which, if
not avoided, may result in minor / moderate injury or product/
property damage. It also alerts against unsafe practices.
IMPORTANT SAFEGUARDS
WARNING-- To reduce the risk of fire, electric shock, or
serious personal injury
• Do not immerse the product in liquids
• This product is not intended for use by children and
contains small parts that may pose a choking hazard to
children under the age of three. Keep the product out of
the reach of children and pets.
• Do not use an electrical device or appliance with this
product whose electrical specifications exceed those
specified in the “Electrical Specifications” section of this
manual.
CAUTION-- To reduce the risk of personal injury or product/
property damage:
• This product is intended for non-commercial, non-industrial
use in the remote control of two electrical outlets. Do not
use this product for any other purpose.
SET UP
1. Plug receiver into a standard 125-volt AC electrical outlet.
2. Confirm that the electrical specifications of an item you wish to use with this
product do not exceed those specified in the “Electrical Ratings” section.
plug the item into an outlet of the receiver.
3. Remove the plastic battery tab from the battery compartment in the back of
the remote control to activate the DC 12V Type A23 pre-installed battery.
ELECTRICAL RATINGS
RC-022 + TR-15-1 Indoor Wireless Remote Control
Voltage Frequency Electronic Ballast Tungsten Amperage Horse Power Ballast
125VAC 60Hz 500VA 1000W 15A 1/2HP 120Vac 60Hz 8.3Ballast
When using electrical products, always follow basic safety
precautions including the following:
OFF
ON
RECEIVER MODEL #RC-022
TRANSMITTER MODEL #TR-015-1
FCC ID: PAGTR-015-1
TO USE
1. To set up the receiver (outlet) with connecting device.
2. Removes the plastic battery tab from the battery compartment in the back of the
remote control to active the DC 12V Type A23 pre-installed battery.
3. To activate the receiver, press the “ON” button of the remote control.
The red LED of the remote control will illuminate momentarily and the LED of the
receiver will remain illuminated.
4. To turn the receiver OFF, press the “OFF” button of the remote control. The LED on
the receiver will shut off.
Battery Handling and Usage
WARNING: Keep batteries away from children and pets.
Follow the battery manufacturer’s safety and usage instructions.
Insert the battery observing the proper polarity (+/-) as indicated inside the Battery
Compartment.
CAUTION: Failure to properly align the battery polarity can cause personal injury
and/or property damage.
Remote a spent or discharged battery from the product. remove the battery
when not using the product for an extended period.
Never throw batteries into a fire. Do not expose batteries to fire or other heat
sources.
Battery contains mercury. Do not put in trash. Recycle or manage as hazardous
waste.
•
•
•
•
•
RECEIVER MODEL #RC-0
TRANSMITTER MODEL #TR-015-
FCC ID: PAGTR-015-