User's Manual

Timer With Remote Control Instruction Sheet
Timer Dial position Using the Remote
Press the remote and the timer will turn OFF
Press the remote and the timer will turn ON
OFF
ON
Press the remote and it will go into a manual restart mode. The
timer will restart from ‘0’ and count until it reaches the time set
on the dial, or dawn. Please refer to examples below for further
explanation.
DUSK-DAWN
2, 4, 6 or 8 HRS
SAFETY INFORMATION:
Let the switch hang downward so moisture does not accumulate in the outlet. Install cord
and unit at twice the product height above ground level with the receptacle facing downward.
Red indicator light is lit when the outdoor receiver/switch is on. Store indoors when not in
use. Suitable for damp locations. Not for water immersion or for use where directly exposed
to water.
SPECIFICATIONS:
14/3 AWG SJTW vinyl cord
RATINGS:
120 V, 60 Hz, 15 A general purpose
1000 W tungsten
RECEIVER MODEL #TM-016
TRANSMITTER MODEL #TR-009S
WARNING:
Federal Communications Commission Interference Statement
This equipment has been tested and found to comply with the limits for Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation
of the device.
FCC Caution: Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate this equipment.
CAUTION:
• Risk of fire. Not for permanent installation. Use only with outdoor equipment, Christmas
tree, or other seasonal decorative-lighting products having a total of 2 ampere maximum.
Do not install or use this product for more than a 90-day period.
• If using Christmas tree or decorative-lighting products that are not marked with an ampere
rating, connect no more than 140 screw-base lamps (C7 or C9) or 2 strings with midget
(push-in) lamps to this cord set.
• Cord sets shall be plugged into a GFCI-protected receptacle.
• If using an outdoor-use cord set for an extended period of time ( greater than 90 days ),
please consider hard wiring a permanent outdoor-use receptacle rated for year-round use
in the area that power is needed. Please contact a licensed electrician for proper
installation of permanent wiring.
• After completion of installation, the connector shall be maintained a minimum of 6 in.
above ground.
• SUITABLE FOR INDOOR/OUTDOOR USE – STORE INDOORS WHILE NOT IN USE.
• CAUTION: PLUG INTO GROUND FAULT PROTECTED RECEPTACLE ONLY.
• Position the timer away from other light sources. If the timer is too close to other light
sources, or if the photocell is facing a light source such as a porch light or streetlight, the
photocell may turn off the fixture outside of the timed settings. If this happens, relocate the
timer or eliminate those other light sources.
• Always unplug when not in use.
• Do not unplug by pulling on cord.
• Before using your timer, please read the following instructions carefully.
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
Lights do not turn
on at dusk. Lights
do not turn on,
even when timer is
in “Always On”
position.
Lights are not in “ON”
position, lights are not
functioning, or timer is
not receiving power.
Be sure that lights are functional by
plugging them directly into the outlet. Be
sure that lights are in “ON” position if they
have their own switch. Be sure that the
outlet that the timer is plugged into is
active.
Lights do not turn
ON and OFF at the
requested time.
Batteries are no longer
functioning, or timer is
not set properly.
Confirm timer program.
Replace batteries in
remote control.
MADE IN CHINA
1. Installation
a. Mount the timer onto a wall near a grounded electrical outlet with the photo sensor
facing outward.
Note: To ensure proper operation of automatic function, ensure photocell sensor is
shielded from all nighttime sources of light, i.e. floodlights.
b. Insert nail or screw (not included) into mounting surface. Nail or screw head must
extend at least 3/16 in. out from the wall. Hang the receiver from the slot on back of
the unit onto the nail or screw. Plug the power supply cord of the receiver into the
outlet.
c. Plug the device cord into any of the two receptacles at the bottom of the receiver.
Dial position Function
Power OFF
Power ON
OFF
ON
Powers ON at dusk, OFF at dawnDUSK-DAWN
ON at dusk – OFF in 2 hours2 Hrs
ON at dusk – OFF in 4 hours4 Hrs
ON at dusk – OFF in 6 hours6 Hrs
ON at dusk – OFF in 8 hours8 Hrs
2. Programming on/off settings
Rotate the dial on the timer to select one of the following settings
3. Timer and remote interaction
Your timer includes a remote control with temporary override:
• Temporary override ON: turns the timer ON for desired settings (2, 4, 6 or 8 Hours).
Please note that if the timer is set to a 2-, 4-, 6- or 8-hour mode, it will come on at dusk
and will turn off 2, 4, 6, or 8 hours later.
• Temporary override OFF: turns the timer OFF for 12 hours before switching control
back to the timer.
4. Examples
• Timer set to DUSK-DAWN When DUSK = 6:00 PM and DAWN = 5:00 AM. If at 4 :00 PM
REMOTE activated to ON --> TIMER OUTPUT ON and stays ON until 5:00 AM. Next
day, ON at DUSK, OFF at DAWN. If at 10:00 PM REMOTE activated to OFF --> TIMER
OUTPUT OFF = 10:00PM and stays OFF until DAWN next day. Next day ON at DUSK,
OFF at DAWN.
• If TIMER setting is 2 HOURS (or 4, 6, 8 HOURS and so on) DAY OR NIGHT TIME
REMOTE ON --> TIMER OUTPUT ON 2 HOURS (4, 6, 8 HOURS) then OFF. When
DUSK --> TIMER OUTPUT ON 2 HOURS (4, 6, 8 HOURS) then OFF. If DUSK is at
6:00 PM:
(1) If at 5:00 PM REMOTE set ON, then TIMER OUTPUT ON immediately until 8:00 PM
(as time count restarted at dusk time).
(2) TIMER ON = 6:00 PM, TIMER OFF = 8:00 PM. If at 1:00 PM REMOTE set ON, then
TIMER OUTPUT turns ON until 3:00 PM.
(3) TIMER ON = 6:00 PM. If at 7:00 PM REMOTE set ON TIMER OUTPUT ON until
9:00 PM (as time count restarted at time remote activates to ON).
(4) TIMER ON = 6:00 PM. If at 7:00 PM REMOTE set OFF, then TIMER OUTPUT turns
OFF immediately until next day.
• Dispose or recycle spent/discharged batteries in compliance with all applicable laws. For
detailed information, contact your local solid waste authority.
6. Battery replacement
• Remove the battery compartment cover from the back of the remote
control by sliding the over in the direction that its treads curve.
• Remove the spent battery and place a new DC 12V Type 23A battery
into the battery compartment, correctly observing the polarity indications
(+/−) inside the battery compartment.
• Replace the battery compartment cover.
5. Remote control unit
• RF (radio frequency) transmitter is powered by one 12V lkaline battery.
• Red indicator light (1.)
• Flickers when transmitting.
• Remote operates the receiver.
• Chain and key ring (2.) for pocket or purse key ring use
• Replace battery when red indicator light (1.) does not flicker when a
button is pressed.
+ 23AC 12V -
TR-009S