User's Manual

ManualsBrandsKab ManualsElectronicsRemote control

Thank-you for purchasing our Woods Model TM16+RC Series – 24 HR Outdoor Lighting Timer

with Remote Control.

Before using your timer, please read the following instructions carefully.

FEATURES

• Wirelessly turns lights and appliances on/off up to 50’ or 15m away

• Choice of operating mode – dusk to dawn, 2 –8 Hour settings or manual on

• Dual outlets – can control two devices

• Easy to install – just plug it in.

INSTALLATION

1. Mount the timer onto a wall near a grounded electrical outlet with the photo sensor facing

outwards. (Note:) To ensure proper operation of automatic function. Ensure

photocell sensor is shielded from all night time sources of light i.e. floodlights).

2. Nail or screw head must extend at least 3/16” out from the wall (nails or screws not

included). Hang the receiver from the slot on back of the unit onto the nail or screw. Plug the

power supply cord of the receiver into the outlet.

3. Plug the device cord into any of the two receptacles at the bottom of the receiver.

PROGRAMMING ON/OFF SETTINGS

Rotate the dial on the timer to select one of the following settings

Dial position Function

OFF Power OFF

ON Power ON

DUSK-DAWN Powers ON at dusk, OFF at dawn

2 Hrs ON at dusk – OFF in 2 hours

4 Hrs ON at dusk – OFF in 4 hours

6 Hrs ON at dusk – OFF in 6 hours

8 Hrs ON at dusk – OFF in 8 hours

Summary of content (4 pages)

PAGE 1
Thank-you for purchasing our Woods Model TM16+RC Series – 24 HR Outdoor Lighting Timer with Remote Control. Before using your timer, please read the following instructions carefully. FEATURES • Wirelessly turns lights and appliances on/off up to 50’ or 15m away • Choice of operating mode – dusk to dawn, 2 –8 Hour settings or manual on • Dual outlets – can control two devices • Easy to install – just plug it in. INSTALLATION 1.
PAGE 2
TIMER AND REMOTE INTERACTION Your timer includes a remote control with temporary override: • Temporary override ON: turns the timer ON for desired settings (2, 4, 6 or 8 Hours). Please note if your timer dial position is preset it will restart from ‘0’ and count until it reaches the time set on the dial refer. • Temporary override OFF: turns the timer OFF for 12 hours before switching control back to the timer.
PAGE 3
If DUSK is at 6:00 PM (1) If at 5 :00 PM REMOTE set ON , then OUTPUT ON immediately until 8:00 PM (as time count restarted at dusk time). (2) TIMER ON = 6:00 PM, TIMER OFF = 8:00 PM. If at 1 :00 PM REMOTE set ON , then OUTPUT turns ON until 3:00 PM. (3) TIMER ON = 6:00 PM. If at 7:00 PM REMOTE set ON OUTPUT ON until 9:00 PM(as time count restarted at time remote activates to ON). (4) TIMER ON = 6:00 PM. If at 7:00 PM REMOTE set OFF, then OUTPUT turns OFF immediately until next day.
PAGE 4
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.