User's Manual

Backup key
Exterior assembly
Bolt
Cross bolt
Interior assembly
Battery
cover
Mounting
plate
Mounting
screws(2)
RX-C
User Manual
www.kaadasgroup.com
Shenzhen Kaadas Intelligent Technology Co.,Ltd reserves all rights
for the final interpretation to this user manual
All design and specifications are subject to change without notice.
Specifications
2
Installation Guide
1
Keypad
Battery cover
Wireless
module
socket
Reset button
Thumb turn
Cylinder
Micro USB port
Reboot button
Exterior assembly Interior assembly
Preparing for Installation
3
Optional Bolt
Faceplate
Addtional Parts Tools Needed
Lock installation
#2 Philips screwdriver
Important Notice:
Make sure your door is prepared prior to installation.
Only drill a upper hole if you wish the lock to have
added stability. Please refer to the provided templatefor
drilling if needed.
Door prep
1. 2-1/8” (54mm) hole saw
2. 1” (26mm) boring bit
3. 7/64” (2.5mm) drill bit
4. 3/8” (10mm) drill bit
5. Chisel&Hammer
A. Measure the dimension of the hole shown.If the measurement is 1-1/2”(38mm), remove the fire cup.
Fire
cup
φ1-1/2”
(38mm)
φ2-1/8”
(54mm)
No adjustment needed.
C. Adjust the deadbolt.
NOTE: Bolt ships with backset in 2-3/8”(60mm) position. If required, turn the bolt case and pull to extend to
2-3/4” (70mm)backset position. (see picture below)
φ2-3/8”
(60mm)
φ2-3/4”
(70mm)
φ2-3/8”
(60mm)
φ2-3/4”
(70mm)
1 2
B. Change faceplate,if necessary.
No change
necessary.
Door
edge
Door
edge
1
2 3
Installation
4
1. Install strike on the door frame.
NOTE: Make sure to allow for the bolt to be centered in the strike.
or
strike
3. Make sure the bolt in retracted(unlocked) postion.
NOTE: The bolt must be in retracted (Unlocked)
position before installing the lockset.
2. Use a screwdriver to test if deadbolt works smoothly.
4. Hold the exterior assembly flush to the door, pull
the key tailpiece and cable through the door hole.
This hole is for the optional
cross bolt provided for
stabilizing your lock. If you
drilled a hole, securely tighten
the post before mounting on
you door.
NOTE: Cable must go through
door hole under the bolt.
NOTE: The tailpiece should be
kept in a horizontal position.
5. Positon the inside mounting plate by first routing
the cable and connector throughthe mounting
plate’s cable hole.
6. Secure both assemblies using 8/32x34 and1/4x65
screws.Make sure that exterior assembly is vertically
aligned.Tighten securely with a #2 Philips screwdriver.
7. Attach cable assembly to the interior assembly
PCB by lining up notches on top of cable connector
to slots on PCB
connector.
Press connector
in firmly using
thumbs untill
commpletely
connected.
Cable connector
PCB connector
six month
158mm(L)x71mm(W)x29mm(H)
6-7/32”x2-51”/64x1-9/64”
179mm(L)x72mm(W)x47mm(H)
7-3/64”x2-53”/64x1-27/32”
PdfEditor 4.0.0.14 Testversion - https://www.pixelplanet.com/de/pdfeditor/