DB1 Series Programming Instructions
Warnings Failure to follow these instructions could result in damage to the product and void the factory warranty. The accuracy of the door preparation is critical for the proper functioning and security of this product. Misalignment can cause performance degradation and lessening of security. Finish Care: This lockset is designed to provide the highest standard of product quality and performance. Care should be taken to ensure a longlasting finish. When cleaning is required use a soft, damp cloth.
Programming Definitions Master Mode: The Master Mode could be entered by entering “**+Master PIN Code+#” to programming the lock. Master PIN code: The Master PIN Code is used for programming and for feature settings. The default Master PIN Code must be changed after installing. The Master PIN Code will also operate the lock in Away Mode.
Lock Operation Definitions -Add Up User PIN Codes Wrong Code Entry Limit: After a specified number of unsuccessful attempts at entering a valid PIN code the lock will shut down and not allow operation. Wrong code entry limit is 10 times. Reboot button: When the system crash down, the lock could be restart by pressing Reboot button on outside escutcheon. Reset button: After reset operation, the lock will be restored to factory default settings, all user credentials will be deleted. Refer to reset guide.
Feature Programming Through Menu Mode using Master PIN Code Lock Operation -Silent Mode(Beeper enable/disable) Silent Mode feature can only be programmed through the Master PIN Code or Alfred APP. 1. Touch the screen with your hand to activate. 2. Enter “*” twice and the Master PIN Code followed by “#”. 3. Enter “51+ #” to enable beeper.(Default setting) Enter “52+ #” to disable beeper.
How to use How to use Unlock the door Unlock with Fake PIN code 1. Unlock the door from outside - Use PIN code key User PIN code User can prevent PIN code exposure from strangers by entering random digits before or after PIN code. 2.
FCC Statement: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
