BTH182H True Wireless Bluetooth Headset User’s manual
Contents Brief introduction…………...…………………………..…... 1 Before use……………………………………………………. 1 1. Overview…………………………………………………...……1 2. Charging for earbuds..……………………………………………2 3. Charging for charging case.. …………………………………2 Getting started……..…………………………………………3 1. Wearing earbudst.............................................................3 2. One earbud connecting with cellphone ......................................3 3. Two earbuds connecting with cellphone..........................................5 4.
Welcome to use this True Wireless Bluetoothearbuds, BTH182H. Please read this user’s manual carefully before use. Brief introduction BTH182H is a True Wireless Bluetooth Earbuds ,each ear piece comes with a Microphone that can be used individually or used together for stereo sound.The earbudsare equipped with a charging case, which is convenient to carry and charge. The charging case supports wireless charging, and you can charge the charging case with your wireless charger. Before use 1.
2. Charging for earbuds When the earbuds are low on power, the earbuds emit “Battery low” once and thered Led flashes slowly four times every 1 minute. Please recharge the battery of the earbuds. The way of charging for the earbuds as following: 1. Put the earbuds into the charging case to ensure that the charging case connect well, and start charging when you see the red LED of the earbuds on. Red light on: Charging Red light off: Finish charging 2. Charging should be completed in roughly 1.5 hours.
If you do not use the earbuds and charging case for a long time, it is recommended to charge the earbuds and charging case for at least 3 months to avoid the battery exhaustion and enter the sleep mode. 3. Charging for charging case When you put the earbuds into the charging case and find that the green indicator light flashes once every 2 seconds, it means that the battery level of the charging case is low.
Remarks: 1) The battery is recyclable. 2) Batteries (battery pack or batteries installed) shall not be exposed to excessive heat place, such as sunshine, fire or the like. 3) Please make sure the charging jack is dry before charge. 2 Getting started 1. Wearing headset a. Choose the suitable size ear tips b. Ensure each earbuds is worn on the correct ear. “L” should be worn on the left ear and “R”worn on the right ear. Left ear Right ear 2.
earbuds and the cellphone fails to connect back, the earbuds will automatically enter the matching state. 2) If the earbuds are power off, you should press touch-button for about 5s and release it when the red LED and blue LED flash quickly and alternately. The earbuds are in”Pairing”mode. 3 3.Connecting To connecting your earbuds to a Bluetooth device, first ensure the device has Bluetooth enable and it is in pairing mode(See your device manual for setting pairing mode) .
mobile phone after 2 minutes, the earbuds will shut down automatically. 3.Two earbuds connecting with cellphone In this mode use two earbuds at the same time to enjoy stereo sound. 1)Turn on any one of earbuds and connect it with you Bluetooth device,then power on the other earbud or take out it from the charging case, and it will connect with each other automatically.
3.The earbuds will enter TWS pairing mode automatically when they are entered the TWS pairing mode (indicator light status: red and blue lights flash slowly).After successful connection, the primary earbud(L) will enter pairing mode: red LED and blue LED flash alternately(it keeps waiting to be paired with your phone), while the secondary earbud(R) will be: blue LED flash twice time every 10 seconds.
switch Active SIRI bass Connected device Four click touch-button “ Voice dial ” after Du tone Four click touch-button 2.
1.
Press touch - Press touch Dang button about 2s button about 2s Double-click Double-click End calling During a call Du touch-button touch-button Voice Press touch Press touch switch to During a call button about 2s Dang button about 2s phone Voice Press touch Press touch switch to During a call button about 2s Dang button about 2s earbuds N/A Once-click Volume up During a call N/A touch-button Volume Once-click During a call N/A N/A down touch-button Reject Incoming call ringing 3. .
Full charge 8. Meaning of indicator light indicator light Earbuds Red and blue LED flash quickly alternately Red and blue LED flash slowly alternately Blue LED flashes once every 2 seconds Blue LED flashes twice every 10 seconds Red LED flashes four times every minute Charging No indicator light will light up case in the charging case without charging or putting the earbuds into the case The number of green LED represents the current battery power of the charging case.
9. Factory Reset When the earbuds are in the pairing mode, five times click the touch button, and the factory reset when the red light turns on for 1 second. At the same time, you will hear "Power off" prompt after Four Tone _ High Falling and turn off. Five times click the touch button Remarks: After factory reset, the paired list of two earbuds as well as earbuds and mobile phone will be deleted. The earbud does not automatically reconnect the mobile phone and the other earbud after turning on.
Don’t use intensive chemical products or detergent to clean the product. Don’t scratch the surface with sharp things. In case the product doesn’t function properly, send it to the store you bought it. The staff will help you to solve the problem FAQs 1. What does it mean when red LEDflashes four times every one minute slowly? Battery is low power, need to be recharged. 2. Why is the red LED off when charging? a) The charging case may not have enough power to charge the headset.
earbuds) Charging time for earbud Charging time for case cycle count of the charging case to charge the earbuds Charging input Weight Measure Up to 8 hours (50% volume) About 1.5 hours About 2 hours More than 2 times DC 5.0V /500mA One earbud: 6.0 g Charging case:34.5g Earbud:22.5*18.8*26.5 mm Charging case:67.5*45.3*31.5 mm NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
