CPE-A311
Contents 2.Work,ng diagram 3.Settings of connection with internet by Ethernet 4.Settings of connection with internet by 3G/4G network 5 WIFI connection and settings 6.WEB connection and settings 7.Fault judgement and Precautions 1 3 3 4 5 6 7 !.
2F F 12345678 13 9101111215 14
5/N Icon Functions On: CPE connected with power supply, the light is on under power-on status. Off: CPE disconnected with power supply, the indicator light is off 2 。 3 垂 On: After CPE starts up, the indicator light is on if SIM card ,s inserted .
12 13 14 Upgrade software. SIM card Insert SIM card, ,tis used for connecting with network. Support standa「d SIM card slot LAN To provide wired data t「ansmission lo「 the LAN port terminal. It interface 1s used for connecting a computer or other local area network equipment TEL : 15 USS Dial up phone. Table 1· interface andstatus indicator lights description _S e sen am pm 5 wreqt 咋 I n ' 口 ` , 2.
2).Power on CPE , all indicator lights on panel are on one time, later the power indicator light is on, WIFI indicator light is on, the device starts up completely 3). Connect the Ethernet cable to the ETH1 port and the indicator light of ETH1 is on. Make sure the Ethernet can connect with network successfully 4).Connect the terminal device with the CPE _WIFI , the WIFI indicator light blinks. The device connection is successful that indicates that the network is connected 4.
Model No.: CPE-A311 Power Supply:12V/1A IP:192.168.100.
Iphone Windows 10 Connect China Mobile Set up VPN connection Open Select network.. Already connected..
7.
a. If the indicator light is on within 3 minutes , which means the CPE is searching the network b. If the indicato「 light 1s on more than 3 minutes without blink ing , which means the base station network cannot be detected by the CPE , please change the CPE placing position and retry Precautions : 1. Place the CPE in a horizontal position to avoid damage from shaking or falling 2.
FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: This device may not cause harmful interference. This device must accept any interference received, including interference that may cause undesired operation. any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.