PORTABLE MINIDISC RECORDER GRABADOR PORTÁTIL DE MINIDISC ENREGISTREUR DE MINIDISC PORTABLE XM-R70SL/BK INSTRUCTIONS MANUAL DE INSTRUCCIONES MANUEL D’INSTRUCTIONS For Customer Use: Enter below the Model No. and Serial No. which are located either on the rear, bottom or side of the cabinet. Retain this information for future reference. Model No. Serial No. LVT0335-005A [J] XM-R70(J)_Cover1-4.
IMPORTANT FOR LASER PRODUCTS / IMPORTANTE PARA LOS PRODUCTOS LÁSER / IMPORTANT POUR LES PRODUITS LASER 1. CLASS 1 LASER PRODUCT CAUTION! 2. DANGER: Invisible laser radiation when open and THIS PRODUCT UTILIZES A LASER. interlock failed or defeated. Avoid direct exposure USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE to beam. OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN 3. CAUTION: Do not open the top cover. There are MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.
ATTENTION! 1. PRODUIT LASER CLASSE1 CET APPAREIL EST DOTÉ D'UN LECTEUR AU LASER. L'UTILISATION DE COMMANDES OU LE RECOURS À DES RÉGLAGES AUTRES QUE CEUX INDIQUÉS DANS CE MANUEL PEUVENT PRÉSENTER DES RISQUES D'EXPOSITION À DES RADIATIONS. NE PAS OUVRIR LE BOÎTIER. TOUTE RÉPARATION DOIT ÊTRE FAITE PAR UN PERSONNEL QUALIFIÉ ET NON PAR L'USAGER. 2. ATTENTION: Radiation laser invisible quand l'appareil est ouvert ou que le verrouillage est en panne ou désactivé. Eviter une exposition directe au rayon.
English Thank you for purchasing this JVC product. Please read these instructions carefully before starting operation to be sure to obtain optimum performance and a longer service life from the unit. Table of Contents Supplied Accessories .................................................... 1 Location of Controls ..................................................... 1 Power Supply Preparations ........................................... 2 Accidental Operation Prevention Function (Hold Mode) ..............
English Power Supply Preparations As a power supply source, you can use the rechargeable battery and/or dry-cell batteries, or AC adaptor. For information on operating times of batteries, refer to the specifications (page 16). Using lithium–ion battery (rechargeable battery) (BN-R3610) 1 Insert the rechargeable battery into the unit. Cut part Slide the cover and open it. Insert the battery with its “–” terminal facing you and its cut part facing up. Firmly close the cover.
English Note The unit is in the standby condition when the AC adaptor is connected. The primary circuit is always “live” as long as the AC adaptor is connected to an electrical outlet. Battery indicator The battery indicator appears on the display of the unit and remote control. When the indication changes as follows, power will be shut off a short while after. Rechargeable battery: Recharge it. Dry-cell batteries: Replace them with new ones.
6 Press the 6 button on the unit or remote control. [Unit’s display] Disc mark turns. English Playback will start from the first track and ends after playing all the tracks of the MD. [Remote control’s display] Peak Level Meter Disc mark turns. Track title Playing time Number of tracks being played Number of tracks being played Playing time To eject the MD, slide the OPEN switch to open the lid and open it by hand. Then, the MD comes out.
English Showing the Disc Information Each time you press the DISPLAY / CHARA. (or DISPLAY) button in Stop mode or during playback, the disc information is displayed as follows. The DISPLAY / CHARA. button on the unit and the DISPLAY button on the remote control work independently. or Display change on the unit: In Stop mode: Disc title*, total track number, and total playback time of the MD = Recordable capacity (remaining time) of the MD (e.g.
English Selecting the Operational Options of Remote Control Muting a pip tone When you press the buttons on the remote control, a pip tone is issued except for the A.C.BASS and VOLUME +, – buttons. To mute the pip tone, while pressing and holding the A.C.BASS button in Stop mode or during playback, press the P.MODE button. “BEEP OFF” appears on the display. To resume a pip tone, do the same operation again. “BEEP ON” will appear on the display.
English Check Items Before Starting Recording • The MD is not the Play-only type one. • The accidental erasure prevention knob of the MD cartridge is set to the close position. • The MD has enough space for recording. If not, carry out ALL ERASE or ERASE function mentioned later to erase all the tracks or desired tracks in the MD. You can check the recordable remaining time of the MD by repeatedly pressing the DISPLAY/CHARA. button on the unit in Stop mode. (See “Showing the Disc Information” on page 5.
English SYNCHRO Recording (SYNCHRO) The synchro recording automatically starts when an input signal is given and ends if no signal condition continues for 30 seconds. 1 2 3 Insert an MD with its label side facing up. Set the REC MODE switch to SYNCHRO. Slide the REC button. “SYNCHRO REC ON” appears and the “SYNC” indicator lights up on the display. Then, the disc mark blinks. 4 Press the 6 button. The “SYNC” indicator blinks, indicating that the unit enters Rec/Standby mode.
English Dividing Tracks (DIVIDE Function) Use the unit to carry out this function. 1 In Stop mode, press the EDIT/ENTER button and turn the JOG dial until “DIVIDE?” is displayed. 2 Press the SET button and then press the 6 button. JOG dial Track to be divided Playing time 3 Turn the JOG dial (or press the 4 or ¢ button) to select the tack number to be divided. 4 Press the SET button at the point where the track is to be divided.
1 In Stop mode, press the EDIT/ENTER button and turn the JOG dial until “MOVE?” is displayed. 2 Press the SET button. 5 Turn the JOG dial (or press the 4 or ¢ button) to select the destination to which the track is to be moved. JOG dial Track to be moved • You can listen to the track by pressing the 6 button. The track to be moved is repeatedly played. 3 4 Turn the JOG dial (or press the 4 or ¢ button) to select the tack number to be moved. Press the SET button.
English Giving Titles to MD (TITLE Function) Use the unit to carry out this function. • You can give a disc title to the MD and a track title to the tracks in the MD. Any title name can be give up to 64 characters using the provided character sets. 1 (or press the 4 button) until the following disc mark is shown on the display. In Stop mode, press the EDIT/ENTER button. “TITLE?” is displayed. 2 4 Press the SET button. Press the SET button.
Listening to MDs with an audio system You can listen to MDs through your audio system. • Connect a stereo connection cable (not supplied) as shown on the right after turning off the amplifier. • Adjust the volume level of the unit to an appropriate level. • Adjust the volume level on the amplifier. • Use the unit’s buttons for operation. (The remote control will issue a pip tone.
English Carrying batteries: When putting dry cell or rechargeable battery in a pocket or bag, ensure that no other metal objects such as a necklace are placed together with them. Contact with metal may cause short-circuiting which, in turn, may cause a fire. Notice about the rechargeable battery. The battery is designated recyclable. Please follow your local recycling regulations. AC adaptor • Handle the AC adaptor carefully. Improper handling is dangerous. • Do not touch it with wet hands.
Within recordings, there are sounds which cannot be readily heard. For example, as the volume decreases, high-pitched sounds and low-pitched sounds become difficult to hear. Also, if a quiet sound comes at the same time as or just after a loud sound, it will not be heard. With minidiscs, data is compressed using a technology called ATRAC (Adaptive Transform Acoustic Coding) which selectively chooses sounds based on human sense of hearing characteristics.
English Minidisc Limitations The minidisc records information in an original format that differs from that of conventional cassette tapes or DATs. Since there are some limitations with this recording format, the following types of conditions may arise. These conditions are not malfunctions. Condition Cause “DISC FULL” is displayed, even though the pos- With the minidisc, there is a maximum number of tracks which sible recording time is not used up. can be recorded, regardless of time.
English Troubleshooting Guide Before requesting service for this unit, check the chart below for a possible cause of the problem you are experiencing. Some simple checks or a minor adjustment on your part may eliminate the problem and restore proper operation.
VICTOR COMPANY OF JAPAN, LIMITED Printed in Japan EN, SP, FR XM-R70(J)_Cover1-4.