JVC KS-DR2104DBT COMPACT BLUETOOTH® 4 CHANNEL DIGITAL AMPLIFIER INSTRUCTION MANUAL AMPLIFICATEUR BLUETOOTH® COMPACT 4 CANAUX NUMÉRIQUE MODE D’EMPLOI AMPLIFICADOR DIGITAL COMPACTO BLUETOOTH® DE 4 CANALES MANUAL DE INSTRUCCIONES JVCKENWOOD Corporation ■ Accessories / Accessoires / Accesorios ① Remote control unit Télécommande Mando a distancia Self-tapping screws Vis taraudeuses 1 ④ 4 Tornillo autorroscantes Ø4×16 mm ② Mounting bracket Support de montage Ménsula de montaje 1 ⑤ Double-side adhesive
Safety precautions IAWARNING I To prevent injury or fire, take the following precautions: • Mounting and wiring this product requires skills and experience. For safety's sake, leave the mounting and wiring work to professionals. • To prevent a short circuit, never put or leave any metallic objects (such as coins or metal tools) inside the unit. • If the unit starts to emit smoke or strange smells, turn off the power immediately and consult your JVC dealer.
■■■ How to reset Comment réinitialiser Cómo reinicializar I I- - I Press and hold and . Maintenez enfoncée et . Pulse mantenga pulsado y . - I I I 50 Watts RMS × 4 at 4 Ohms and ≤ 1% THD+N 74 dBA (Reference: 1 Watt into 4 Ohms) 50 Watts RMS × 4 à 4 Ohms et ≤ 1% THD+N 74 dBA (Référence: 1 Watt dans 4 Ohms) 50 Vatios RMS × 4 a 4 Ohmios y ≤ 1% de distorsión armónica total+N 74 dBA (Referencia: 1 Vatio en 4 Ohmios) Troubleshooting guide t Sound cannot be heard. • Check the cords and connections.
■ Dimensions / Dimensions / Dimensiones 200 mm (7-7/8”) 198 mm (7-13/16”) 48.5 mm (1-15/16”) 181 mm (7-1/8”) ~ ~ 88 mm (3-7/16”) JVC drun t---------45.1 mm (1-3/4”) 84.0 mm (3-5/16”) ( 51.0 mm (2”) JVC 52.8 mm (2-1/16”) 99.0 mm (3-7/8”) 27.0 mm (1-1/16”) 25.8 mm (1”) 58.1 mm (2-5/16”) 104 mm (4-1/8”) ..
Installation / Installation / Instalación ■ Installing the unit / Installation de l’appareil / Instalación de la unidad ④ Installation board, etc. (thickness : 15 mm or more) Tableau d’installation, etc. (épaisseur: 15 mm ou plus) Tablero de instalación, etc.
■ Installation procedure Read the instruction manual well to select the proper connection and setting. Refer to "Connections" on the back side. 1. Remove the ignition key and disconnect the negative 0 terminal of the battery to prevent short circuits. 2. Connect the battery wire. 3. Connect the ground wire to chassis ground of vehicle. 4. Connect the power control wire. 5. Connect the speakers. 6. Connect the remote control unit. 7. Attach the unit. 8. Connect the negative 0 terminal of the battery. 9.
For U.S.A. Contains Transmitter Module FCC ID: ZWY3008X IC: 12033A-3008X This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. FCC CAUTION Changes or modifications not expressly approved by the party responsible for compliance could void the user'sauthority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
Connections / Raccordements / Conexiones WARNING Remove the ignition key and disconnect the negative ⊖ terminal of the battery to prevent short circuits. AVERTISSEMENT Retirer la clé de contact et débrancher la borne négative ⊖ de la batterie pour éviter les court-circuits. ADVERTENCIA Retire la llave de encendido y desconecte el terminal negativo ⊖ de la batería para evitar cortocircuitos. NOTE After wiring, be sure to insulate and waterproof the connection part.
WARNING Particular attention must be given to making good electrical contact at the amplifier-output and speaker terminals. Poor or loose connections can cause sparking or burning at the terminals because of the very high power that the amplifier can deliver. CAUTION • If sound is not output normally, immediately turn power off and check connections. • Be sure to turn the power off before changing the setting of any switch.
Controls / Contrôles / Controles ❷ ❶ ❸ This is a 4 channel amplifier including 2 stereo amplifiers in a body. One amplifier is referred to as amplifier CH1-2 (for FRONT) and the other is amplifier CH3-4 (for REAR). This unit is compatible with a large variety of systems by combining the switches and functions described in the following. ❶ FADER control Adjusts the front and rear speaker output balance. ❷ Filter frequency control (FILTER FREQ) (CH.1-2 / CH.
8/uetooth function I Fonction de 8/uetooth I Funci6n de 8/uetooth 3 2 JVC ► II • PAIRING I 1 •I• 1 MIN 2 3 4 5 6 ■ ■ ■ ■ ■ •••• 7 I ■ 11 MAX 1 - - - - - - - • PAE- OUT rn Red/Rouge/Rojo Bluetooth illumination Eclairage Bluetooth lluminacion Bluetooth I ◄◄ Supported Bluetooth profiles -Advanced Audio Distribution Profile (A2DP) -AudioNideo Remote Control Profile (AVRCP) Supported Bluetooth codecs Red/Rouge/ Rojo 0 Connected Connecte Conectado ~\II,:_ " /;I\.;::-- Pairing ...
