User's Manual

ManualsBrandsJVC KENWOOD ManualsElectronicsUHF DIGITAL TRANSCEIVER (Model :TK-5800)

KENWOOD CORPORATION TK-5800 FCC ID: K4437184110

INSTRUCTION MANUAL

THANK YOU!

We are grateful you chose K

ENWOOD for your land mobile radio applications. We believe this easy-to-use

transceiver will provide dependable communications to keep personnel operating at peak efficiency.

KENWOOD transceivers incorporate the latest in advanced technology. As a result, we feel strongly that you will

be pleased with the quality and features of this product.

MODELS COVERED BY THIS MANUAL

The models listed below are covered by this

•TK- 5800 : UHF FM and 4-Level FSK Transceiver

NOTICES TO THE USER

WARNING:

• GOVERNMENT LAW PROHIBITS THE OPERATION OF UNLICENSED RADIO TRANSMITTERS WITHIN THE

TERRITORIES UNDER GOVERNMENT CONTROL.

• ILLEGAL OPERATION IS PUNISHABLE BY FINE AND /OR INPRISONMENT.

• REFER SERVICE TO QUALIFIED TECHNICIANS ONLY.

SAFETY:

It is important that the operator is aware of, and understands, hazards common to the operation of any

transceiver.

WARNING:

• EXPLOSIVE ATMOSPHERES (GASES, DUST, FUMES, etc.)

Turn off your transceiver while taking on fuel, or while parked in gasoline service stations. Do not carry spare

fuel containers in the trunk of your vehicle if your transceiver is mounted in the trunk area.

• INJURY FROM RADIO FREQUENCY TRANSMISSIONS

Do not operate your transceiver when somebody is either touching the antenna or standing within two to three

feet of it, to avoid the possibility of radio frequency burns or related physical injury.

• DYNAMITE BLASTING CAPS

Operating the transceiver within 500 feet (150m) of dynamite blasting caps may cause them to explode.

Turn OFF your transceiver when in an area where blasting is in progress, or where “TURN OFF TWO-WAY

RADIO” sighs have been posted. If you are transporting blasting caps in your vehicle, make sure they are

carried in a closed metal box with a padded interior. Do not transmit while the caps are being placed into or

removed from the container.

PRECAUTIONS

Please observe the following precautions to prevent fire, personal injury, and transceiver damage.

• Do not attempt to configure the transceiver while driving , it is too dangerous.

• Do not modify the transceiver for any reason.

• Do not expose the transceiver to long periods of direct sunlight, nor place it near heating appliances.

• Do not place the transceiver in excessively dusty, humid , or wet areas, nor on unstable surfaces.

• If an abnormal odor or smoke is detected coming from the transceiver, turn OFF the power immediately.

Contact your K

ENWOOD dealer.

FCC WARNING

This equipment generates or uses radio frequency energy. Changes or modifications to this equipment may cause

harmful interference unless the modifications are expressly approved in the instruction manual. The user could

lose the authority to operate this equipment if an unauthorized change or modification is made.

Summary of content (7 pages)

PAGE 1
KENWOOD CORPORATION TK-5800 FCC ID: K4437184110 INSTRUCTION MANUAL THANK YOU! We are grateful you chose KENWOOD for your land mobile radio applications. We believe this easy-to-use transceiver will provide dependable communications to keep personnel operating at peak efficiency. KENWOOD transceivers incorporate the latest in advanced technology. As a result, we feel strongly that you will be pleased with the quality and features of this product.
PAGE 2
KENWOOD CORPORATION TK-5800 FCC ID: K4437184110 INFORMATION TO THE DIGITAL DEVICE USER REQUIRED BY THE FCC This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
PAGE 3
KENWOOD CORPORATION TK-5800 FCC ID: K4437184110 TOOLS REQUIRED Note: Before installing the transceiver, always check how far the mounting screws will extend below the mounting Surface. When drilling mounting holes, be careful not to damage vehicle wiring or parts. The following tools are required for installing the transceiver: • 6mm(1/4 inch) or larger electriic drill • 4.
PAGE 4
KENWOOD CORPORATION TK-5800 FCC ID: K4437184110 ORIENTATION Power Volume None Moni Antenna None Power supply Channel Audio output Functional and Operational specifications 1) Front Panel Switch(Push type) NO.
PAGE 5
KENWOOD CORPORATION TK-5800 FCC ID: K4437184110 3) DISPLAY LCD No.
PAGE 6
KENWOOD CORPORATION TK-5800 FCC ID: K4437184110 • Receiving 1 Select your desired channel. 2 When you hear a signal, readjust the volume level if necessary. 3 Respond to the call as described in step 2 of “TRANSMITTING”,above. AUXILIARY FEATURES • Time-out Timer (TOT) The purpose of the Time-out Timer is to prevent any caller from using a channel for an extended period of time.
PAGE 7
MANDATORY SAFETY INSTRUCTIONS TO INSTALLERS AND USERS • Use only manufacturer or dealer supplied antenna. • Antenna Minimum Safe Distance: 120 cm (4 feet), 50% duty Cycle. • Antenna Gain: 0 dBd referenced to a dipole. The Federal Communications Commission has adopted a safety standard for human exposure to RF (Radio Frequency) energy which is below the OSHA (Occupational Safety and Health Act) limits.