USER’S MANUAL for 2.
Table of contents A. B. C. D. E. F. G. Basic Features.
A. Basic Features 1. Outlook GFSK board size : 21.4mm * 19.5mm Control board size : 31.4mm * 24.9mm GFSK board Control board 2. Performance Nordic’s nRF24L01 with GFSK. Low cost GFSK High power(0dbm) and high performance pattern Antenna(-0.7dB) SPI Interface between GFSK board and Control board. 3. This module is complied with FCC Part15.
B. Shape & Pin Map GFSK board Pin # 12345678 CN1 Control board NAME 1234 1 VCC 2 CE 3 CSN 4 SCK 5 MOSI 6 MISO 7 IRQ 8 GND CN1 CN2 12345678 CN1 Pin # NAME 1 VCC(+3.
C. GFSK board 1. nRF24L01 Nordic’s 2.4GHz GFSK chip. Used frequency 2.402 GHz, 2.422 GHz, 2.432 GHz, 2.449 GHz, 2.462 GHz 2. Controls This board is controlled by Control board via SPI D. Control board 1. S3F94C4 The MCU(S3F94C4) controls GFSK board and send data received from GFSK board to the BIDET. This board is pairing to Remote Control when received pairing signal from BIDET via pin on CN2.
E.
F. Block Diagram Radio(2.4GHz) 2.402 2.422 2.432 2.449 2.
G. Antenna List Pattern Antenna MODEL GFSK module Type Gain[dBi] Impedance PCB pattern -0.
H. Notice. Information on test modes and additional testing requirements a) The modular transmitter has been fully tested by the module grantee on the required number of channels,modulation types and modes, it should not be necessary for the host installer to re-test all the available transmitter modes or settings.
H. Notice. c) If the investigation indicates acompliance concern the host product manufacture is obligated to mitigate the issue. Host products using a modular transmitter are subject to all the applicable individual technical rules as well as to the general conditions of operation in Sections 15.5,15.15,and 15.29 to not cause interference. The operator of the host product will be obligated to stop operating the device until the interference has been corrected.
H. Notice. Additional testing, Part 15 subpart B disclaimer The final host/module combination need to be evaluated against the FCC Part 15B criteria for unintentional radiators in order to be properly authorized for operation as a Part 15 digital device.
H. Notice. FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
H. Notice. This appliance and its antenna must not be co-located or operation in conjunction with any other antenna or transmitter. FCC CAUTION: Any changes or modifications to the equipment not expressly approved by the party responsible for compliance could void your authority to operate the equipment.
H. Notice. Information to user : RSS-247 This device complies with Industry Canada’s licence-exempt RSSs. Please be cautioned the changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Notice: Operation is subject to the following two conditions : (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
H. Notice. IC Radiation Exposure Statement This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT. End Product Labeling The module is labeled with its own FCC ID and IC Certification Number.
H. Notice. Énoncé FCC Cet équipement a été testé et déclaré conforme aux limites pour appareils numériques de classe B, selon la section 15 des Règles de la FCC. Ces limites sont destinées à assurer une protection raisonnable contre les interférences nuisibles dans une installation résidentielle.
H. Notice. Cet appareil et son antenne ne doivent pas être placés à proximité de toute autre antenne ou de tout autre émetteur, ni être utilisés conjointement avec ceux-ci. MISE EN GARDE DE LA FCC : Tout changement ou toute modification à l’équipement qui n’a pas fait l’objet d’une autorisation expresse par la partie responsable d’assurer sa conformité pourrait annuler votre droit à utiliser l’équipement.
H. Notice. Information pour l’utilisateur : CNR-247 Cet appareil est conforme aux exigences des CNR d’Innovation, Sciences et Développement économique Canada pour les dispositifs exempts de licence. Cet appareil est conforme aux exigences des CNR d’Innovation, Sciences et Développement économique Canada pour les dispositifs exempts de licence.
H. Notice. Avis d’Industrie Canada sur l’exposition aux rayonnements Cet appareil est conforme aux limites d’exposition aux rayonnements d’Industrie Canada pour un environnement non contrôlé. REMARQUE : LE FABRICANT N’EST PAS RESPONSABLE DES INTERFÉRENCES RADIOÉLECTRIQUES CAUSÉES PAR DES MODIFICATIONS NON AUTORISÉES APPORTÉES À CET APPAREIL. DE TELLES MODIFICATIONS POURRAIENT ANNULER L’AUTORISATION ACCORDÉE À L’UTILISATEUR DE FAIRE FONCTIONNER L’APPAREIL.
I. US representative Contacts Company name : Coway USA Inc Address : 4221 Wilshire Blvd. #210, Los Angeles, CA 90010 Telephone number : +1 213-480-1600 E-mail : kevin@coway.co.
J. Canadian representative Contacts Company name : Canadian Certification Consulting, Inc. Street Address : 2210 Horizon Drive, Suite 17 City/Province/Zip : West Kelowna, BC V1Z 3L4, Canada Telephone number : 1-250-575-1719 Facsimile number : 1-250-769-0045 E-mail : info@can-cert.