Instructions / Assembly

ASSEMBLY INSTRUCTIONS
(English)
Decorative Nuts
White Wire
Ground Wire
Negative Wire
Black Wire
Live Wire
Mounting screw
Wire Nuts
Mounting Plate
0utlet Box
READ & SAVE INSTALLATION & OPERATION INSTRUCTIONS TOOLS & MATERIALS REQUIRED
·Screwdriver ·Wire Cutters ·Adjustable Wrench ·Wiring Supplies
CAUTION
Prior to assembly, refer to ELECTRICAL CONNECTIONS section. If you do not have
electrical wiring experience, refer to a do-it-yourself wiring handbook or have your fixture
installed by a qualified licensed electrician.
GENERAL
1． Be sure to read these instructions and review the diagrams thoroughly before
. beginning.
2． Electrical connections must be in accordance with local codes, ordinances, or the .
. National Electric Code. If you are unfamiliar with methods of installing electrical . . wiring, secure the services of a qualified licensed electrician.
3． Before starting the installation, disconnect the power by turning off the circuit breaker
. or by removing appropriate fuse at fuse box. Turning the power off at the light switch . is not sufficient to prevent electrical shock.
UNPACK THE FIXTURE
Check the contents of the wire connector. You should receive:
·Mounting Hardware Package ·Unassembled Fixture
PREPARE THE FIXTURE NOTE: First turn off electricity.
1． If replacing an existing fixture, disconnect and remove old fixture. Expose the supply
. wiring from wire connector.
2． If your fixture is supplied with two machine screws, thread the long machine screws
. into the opposite side of the anchors. While supporting the fixture, make electrical . connections.
FINAL ASSEMBLY
1． Spread electrical splices so Black wire are on one side of wire connector and White
. Wire on the other.
2． Install light bulbs (not provided) and cover assembly. Some models employ a twist off
. top cap to allow access to bulbs.
3． CAUTION: Refer to the relamping gtl label located near lamp holder for
. recommended maximum wattage. Do not exceed recommended wattage.
4． Use weather resistant caulk to seal around top and side perimeter of fixture back plate.
. Leave bottom uncaulked to allow for condensation and evaporation.
5． Restore electrical power.