EN by Blum SERVO-DRIVE Instruction leaflet www.blum.
Table of contents About these instructions .......................................................................................................................... 2 Warning signs and danger symbols .......................................................................................................... 3 Safety ........................................................................................................................................................ 3 Disposal ...............................
EN Warning signs and danger symbols WARNING WARNING indicates a danger that could lead to death or serious injury if not heeded. NOTE NOTE indicates information that should be followed. Safety Principle SERVO-DRIVE complies with current safety standards. Nevertheless, certain risk factors will remain if the information contained in this instruction leaflet is not observed.
Intended use SERVO-DRIVE supports the opening and closing of lift systems, the opening of drawers and/or refrigerators and freezers or dishwashers, and may only be used under the following conditions: • in dry, enclosed rooms • in combination with AVENTOS lift systems and/or pull-out systems from Julius Blum GmbH within permitted technical specifications • in combination with a Blum transformer. Technical data specifications can be found in the Blum sales documentation.
EN Structural changes and spare parts Structural changes and replacement parts not approved by the manufacturer affect the safety and functionality of SERVO-DRIVE and are, therefore, not allowed. • Only use original spare parts from Julius Blum GmbH. • Blum components are the only devices that should be connected to the Blum transformer. • Only qualified persons may install or replace Blum components, modify the position of the Blum transformer or modify the cabling.
Children WARNING Opening and closing lift systems may pose a risk of injury to children. Persons, especially children, who are sitting or standing on work surfaces may be pushed from work surfaces or injured when opening and closing a lift system. May pose a choking hazard to children when playing with the SERVO-DRIVE switch. Children could choke on the SERVO-DRIVE switch battery.
EN Cabinet care and cleaning WARNING Danger of death from electric shock! There is a danger of electric shock if fluids penetrate the Blum transformer. Before cleaning the front, turn off the switched outlet to which the Blum transformer is connected. Before cleaning the drive unit and/or Blum transformer, disconnect the Blum transformer from the power.
EN 9
EN 11
Electrical and electronic appliances must not be disposed of with household waste at the end of their service life. Ask your local authority for information on how to proceed. Blum electrical and electronic appliances meet the requirements of the WEEE Directive 2012/19/EU. Electrical and electronic appliances are collected separately, which enables old appliances to reused or recycled, and their materials to be reused.
EN 13
SERVO-DRIVE for AVENTOS/SERVO-DRIVE uno for AVENTOS SERVO-DRIVE for AVENTOS supports the opening and closing of lift systems in furniture. Orientation diagram 1 1 3a 3b Lift mechanism, drive unit and cover cap 2 Lever 2 3a Blum transformer, 24 Watts 5 3b Blum plug-in transformer, 12 Watts 4 SERVO-DRIVE switch 5 Blum distance bumper 6 Cabinet 7 Front/Lift system 4 6 7 SERVO-DRIVE for LEGRABOX/TANDEMBOX/MOVENTO/ TANDEM SERVO-DRIVE supports the opening of drawers.
EN SERVO-DRIVE flex for refrigerators and freezers SERVO-DRIVE flex allows handle-less refrigerators and freezers to be opened electromechanically by pressing the front. Orientation diagram 1 3 2 6 8 5 4 1 Drive unit 2 Catch plate 3 Mounting plate 4 Front fixing 5 Blum distance bumper 6 Assembly jig 7 Front cover 8 Chipboard screws 7 SERVO-DRIVE flex for dishwashers SERVO-DRIVE flex allows handle-less dishwashers to be opened electromechanically by pressing the front.
SERVO-DRIVE for AVENTOS/SERVO-DRIVE uno for AVENTOS Electrical motion support system The SERVO-DRIVE switch triggers the automatic opening and closing action of SERVO-DRIVE for AVENTOS.
EN Manual operation The lift system can be opened or closed manually at any time without damaging SERVO-DRIVE for AVENTOS. Manual opening of the lift system by moving it upwards Manual closing of the lift system by moving it downwards Collision detection The opening and closing action is interrupted automatically via the integrated collision detection feature when the front hits a body part or other object. Leaning protection SERVO-DRIVE for AVENTOS is only triggered by a brief touch.
Power failure If the power supply is interrupted during the opening or closing process, the SERVO-DRIVE for AVENTOS lift system will remain in that position. The front can be closed manually, or when power is The following parameters must be observed to ensure the error-free functioning of SERVO-DRIVE for AVENTOS: • Blum distance bumpers must be attached to the front to maintain the required distance between the lift system and the cabinet. • No items should be placed between the front and the cabinet.
EN Replacing the battery When the battery power begins to weaken, the battery display (LED) will begin to flash red.
SERVO-DRIVE for LEGRABOX/TANDEMBOX/MOVENTO/ TANDEM Electrical motion support system When the front and/or handle of the drawer (A) is pulled or pressed, the eject lever of the drive unit (B) swivels forward and opens the pull-out unit a short distance. Leaning protection The electrical opening support function is only triggered by a brief touch or pull. Leaning on the pull-out unit, for example, will not open it.
EN The following parameters must be observed to ensure the error-free functioning of SERVO-DRIVE: • Blum distance bumpers must be attached to the front to ensure the required triggering signal (2 mm) between the pull-out unit and the cabinet. • No items can be clamped between the pull-out unit and the cabinet back and/or SERVO-DRIVE. Blum transformers Blum transformers provide power to the drive unit. Blum transformer function can be checked via the operating mode display (LED).
SERVO-DRIVE flex Electrical motion support system Pressing the handle-less front will trigger the electromechanical opening of the SERVO-DRIVE flex. 1) Press (do not pull) the front The door (refrigerator or dishwasher) will open slightly for 2.
EN 23
Problems Possible cause Remedy Battery display on SERVO-DRIVE SERVO-DRIVE switch battery switch flashes red. is losing power. Replace the battery. Battery display lights up red Battery has been inserted incorrectly. Insert the battery correctly. SERVO-DRIVE for AVENTOS does not open or close completely. The front is not balanced or does not lie flat on the cabinet evenly. Contact your distributor's customer service to readjust the front.
EN Problems Possible cause Remedy SERVO-DRIVE for The Blum transformer is not Plug in the Blum transformer LEGRABOX/TANDEMBOX/ connected to the power outlet. to the outlet. work on any drawers when The power supply has been Check the circuit breaker/ pushing or pulling. interrupted. fuse box. MOVENTO/TANDEM will not If necessary, contact an authorised electrician. Blum transformer is defective. If necessary, have the distributor's customer service replace the Blum transformer.
Problems The refrigerator door does not open. SERVO-DRIVE flex for refrigerators, freezers and Possible cause If the door of the device is left open for a relatively long time, for example when putting away shopping, a vacuum may be created inside the refrigerator or freezer after it has been closed. This may result in it not being possible to open the door of the device for a few seconds.
EN Problems Door does not close Dishwasher does not close completely Possible cause Remedy Catch plate is not installed Install catch plate Catch plate is positioned incorrectly Reposition the catch plate Dishwasher locking mechanism has become stiff (depending on model) Push front until it closes (this is NOT a product defect) 27
Technical data The appliances must only be used in dry, closed rooms. All SERVO-DRIVE appliances are of protection class III and must only be supplied with safety extra-low voltage (SELV). They are only to be used with the transformers provided by Blum. Input voltage: ......................................................................................100–240 VAC ±10 % / 50–60 Hz Input voltage Japan: ...............................................................................
EN SERVO-DRIVE for AVENTOS HK top drive unit Supply voltage: .......................................................................................................................... 24 VDC Rated current: ................................................................................................................................ 2.0 A Power consumption in standby mode: ................................................................. <0.6 W (front closed) Ambient temperature: ...........................
Simplified EU Declaration of Conformaty Hereby, Julius Blum GmbH declares that all electrical and electronic article types of Julius Blum GmbH are in compliance with Directive 2011/65/EU. Hereby, Julius Blum GmbH declares that the radio equipment types 21LA001, 21SA001, 21KA001, 21FA001, 21P5020 and Z10C5007 are in compliance with Directive 2014/53/EU.
EN Spare parts form Name of kitchen distributor/carpenter: Address: Name of kitchen owner: Address: Commission number: Fault description: Part number Z10N Batch number BN Z10N BN Z10 BAU 21 BAU 23 BAU Quantity BAU Z10C5007 BAU The part number and the batch number can be found here Blum transformer Steckernetzgerät Drive unit SERVO-DRIVE switch Wireless receiver 31
· 07.19 · © Copyright by Blum BA-139/ Julius Blum GmbH Beschlägefabrik Industriestraße 1 6973 Höchst, Austria Tel.: +43 5578 705-0 Fax: +43 5578 705-44 E-Mail: info@blum.com www.blum.