Installation Guide

ManualsBrandsJUGANU ManualsElectronicsJPROTECT

Do not make or alter any open holes in the xture

enclosure of wiring or electrical components during

J.Protect installation.

• J.Protect panel should be installed by a certied licensed

installer in accordance to local law.

• A second person is required for the installation to

support xture weight.

J. Protect is designed for indoor installation in accordance

with the National Electrical Code and all applicable local

codes. Do not use in areas of limited ventilation.

1. Do not install in case xture is damaged.

2. Install on grid and allow a minimum

15mm/6” of clearance.

3. Before installation, turn power o.

FOLLOW THESE INSTRUCTIONS CAREFULLY TO

AVOID DAMAGE TO FIXTURE OR PERSONAL INJURY

J.Protect Allegro – Panel

J.Protect Allegro - LED Panel 60x60 / 2x2

Installation Guide

CAUTION

CAUTION CAUTION

www.juganu.com

Information provided is subject to change without notice. Please verify all details with Juganu. All values are typical values when measured under laboratory

conditions, and Juganu makes no warranty or guarantee, expressed or implied, that such performance will be obtained under end-use conditions.

J.Protect Panel

Installation Guide July 2020

595

Summary of content (3 pages)

PAGE 1
Installation Guide J.Protect Allegro - LED Panel 60x60 / 2x2 J.Protect Allegro – Panel FOLLOW THESE INSTRUCTIONS CAREFULLY TO AVOID DAMAGE TO FIXTURE OR PERSONAL INJURY Do not install in case fixture is damaged. 2. Install on grid and allow a minimum 15mm/6” of clearance. 3. Before installation, turn power off. 1. CAUTION • J.Protect panel should be installed by a certified licensed installer in accordance to local law. • A second person is required for the installation to support fixture weight.
PAGE 2
Installation Guide J.Protect Allegro - LED Panel 60x60 / 2x2 1. Remove ceiling tile or existing fixture 2. Secure lamp to ceiling using supplied safety cables •2 steel cables per fixture are attached •Turn power off before taking out existing fixture AC J.PROTECT GNE NEUTRAL LINE 3. •Safety wire: 2m / 1mm diameter steel wire with 10mm hook and a mechanical lock mechanism Green/Yellow Blue Brown Safely connect to AC power in accordance to diagram. 4.
PAGE 3
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.