ISTATION (Integration Station) User Manual JTECH an HME Company 1400 Northbrook Parkway Suite #320 Suwanee , GA USA 30024 Integration Station Serial Transmitter Page 1
NOTICE This manual, software and electronic circuitry are copyrighted. All rights reserved. Under the copyright laws, this manual, software and electronic circuitry may not be copied, in whole or in part without written prior consent of Lee Technology. All information provided in this document is carefully prepared and offered in good faith as a guide in the installation, use and servicing of our products.
INTRODUCTION Your HME Computer Controlled Paging System has the following capabilities: PC controlled operation via RS-232 serial port 2-Watts effective radiated power with approximately 1-mile open field range Operating Frequency 457.
Power supply connector TESTING THE DEVICE WITH PAGING SOFTWARE This device had been tested to work with QSR, Radiant, Open Table, Pro-Host or any software product that utilizes the standard TAP, WaveWare, or Scope Paging protocols. To test the device using your paging software, follow the procedure below… Add the pagers to the pager list or paging configuration of your existing software. Refer to the list of pager capcodes on the next page.
Locate / All Page Feature This feature causes ALL pagers (that are not charging) to signal at once. This feature is useful when you are closed and would like to locate any misplaced pagers around your facility. To locate ALL pagers, press, 1. “1249 – send” – for IQ, Coaster pagers 2. “912 – send” – for belt clip (Mgr) pagers Any pager not on a charger will signal. Search for the missing pagers by listening for the beep or voice call and looking for flashing lights.
CUSTOMER SERVICE Technical Support 1. This product is programmed specifically for Darden Restaurants (Olive Garden) 2. If you require technical support please call HME Level 2 support at 800-925-8091 x1753 or x1750 and speak to Mel Canlas or Charlie Luangkhot 3. For any questions about this project (non technical) please call Darden’s account manager, Scott Hubbard at 800925-8091 x 1710 4. Make certain the integration station and pagers have power. Check the outlet & circuit breaker. 5.
FCC&IC Compliance Information : This device complies with Part 15 and 90 of FCC Rules. Operation is subject to the following twoconditions: (1) the device may not cause interference, and (2) the device must accept any interference, including interference that may cause undesired operation of this device. NOTE: THE GRANTEE IS NOT RESPONSIBLE FOR ANY CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE.