Integration Station Operating Instructions V 310 Prepared for Olive Garden Restaurants HME Wireless, Inc Customer Service 800.925.8091 1400 Northbrook Parkway Suite #320 • Suwanee, GA 30024 HME 800.
INSTALLATION INSTRUCTIONS INTRODUCTION Your HME Computer Controlled Paging System has the following capabilities: • PC controlled operation via RS-232 serial port • 2-Watts effective radiated power with approximately 1-mile open field range • Operating Frequency 457.
TESTING THE DEVICE WITH PAGING SOFTWARE This device had been tested to work with QSR, Radiant, Open Table, Pro-Host or any software product that utilizes the standard TAP, WaveWare, or Scope Paging protocols. To test the device using your paging software, follow the procedure below… • • Add the pagers to the pager list or paging configuration of your existing software. Refer to the list of pager capcodes on the next page.
O LIVE G ARDEN PAG ER C APC O DE C O NFIG URA TIO N FREQ : 457.
CUSTOMER SERVICE Technical Support 1. This product is programmed specifically for Darden Restaurants (Olive Garden) 2. If you require technical support please call HME Level 2 support at 800-925-8091 x1753 or x1750 and speak to Mel Canlas or Charlie Luangkhot 3. For any questions about this project (non technical) please call Darden’s account manager, Scott Hubbard at 800925-8091 x 1710 4. Make certain the integration station and pagers have power. Check the outlet & circuit breaker. 5.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS : (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. IQ TRANSCEIVER INSTRUCTION MANUAL NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT.
Multicall Paging System User Manual IMPORTANT SAFTEY INFORMATION RF EXPOSURE STATSURE STATEMENT Your Pager Transmitter contains a radio frequency transmitter. When the button is pushed the transmitter sends our RF singnals. CAUTION : To comply with FCC RF exposure compliance requirements, A separation distance of at least 8 inches(20Cm) must be maintained Between the antenna of this transmitter and all persons, during Normal operation.