ISTATION-N (Integration Station) User Manual HME Wireless, Inc Customer Service 800.925.8091 1400 Northbrook Parkway Suite #320 • Suwanee, GA 30024 HME 800.
NOTICE This manual, software and electronic circuitry are copyrighted. All rights reserved. Under the copyright laws, this manual, software and electronic circuitry may not be copied, in whole or in part without written prior consent of Lee Technology. All information provided in this document is carefully prepared and offered in good faith as a guide in the installation, use and servicing of our products.
IMPORTANT SAFETY INFORMATION RF EXPOSURE STATEMENT Your Pager Transmitter contains a radio frequency transmitter. When the button is pushed the transmitter sends our RF signals. CAUTION: To comply with FCC RF exposure compliance requirements, a separation distance of at least 8 inches (20 cm) must be maintained between the antenna of this trasmitter and all persons, during normal operation.
INTRODUCTION Your HME Computer Controlled Paging System has the following capabilities: PC controlled operation via RS-232 serial port. (Using a program provided by the manufacturer only.) 2-Watts effective radiated power with approximately 1-mile open field range Operating Frequency 457.
TESTING THE DEVICE WITH PAGING SOFTWARE This device had been tested to work with QSR, Radiant, Open Table, Pro-Host or any software product that utilizes the standard TAP, WaveWare, or Scope Paging protocols. To test the device using your paging software, follow the procedure below… Add the pagers to the pager list or paging configuration of your existing software. Refer to the list of pager capcodes on the next page.
CUSTOMER SERVICE Technical Support 1. This product is programmed specifically for Darden Restaurants (Olive Garden) 2. If you require technical support please call HME Level 2 support at 800-925-8091 x1753 or x1750 and speak to Mel Canlas or Charlie Luangkhot 3. For any questions about this project (non technical) please call Darden’s account manager, Scott Hubbard at 800925-8091 x 1710 4. Make certain the integration station and pagers have power. Check the outlet & circuit breaker. 5.
FCC ID: WDCISTATIONN This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications (including the antennas) made to this device that are not expressly approved by the manufacturer may void the user's authority to operate the equipment.