Quick-Start Guide Guardian App Cam 26 IP Camera Use this Quick-Start Guide to connect the camera to the network. If you want to set up more cameras later, refer to the online user manual for instructions. In the Box • • • • • • • Camera (x1) Antenna (x1) Mounting Bracket (x1) Ethernet Cable (x1) AC Adaptor (x1) Screw Pack Quick-Start Guide If any item is missing or damaged, contact your place of purchase immediately. Never use damaged products! Need help? Get answers at our website: www.uniden.com.
Important Safety Instructions 1. Do not drop, puncture or disassemble the camera. 2. This camera is NOT waterproof. 3. Never tug on the power cords. Use the plug to unplug it from the wall outlet. 4. Do not expose the camera to high temperature or leave it in direct sunlight. Doing so may damage the camera or cause camera temporary malfunction. 5. For your own safety, avoid using the camera or power off the camera when there is a storm or lightning. 6.
Set Up Camera, Smartphone and Tablet This QSG only shows images for Android devices. Images for iOS devices are similar. Prerequisites • Your router must support WPA/WPA2 security and it must be turned on. • You must have an available WiFi-enabled mobile device (Android or iOS smartphone/tablet). • The Guardian App Cam 26 and your mobile device must connect to the same WiFi router for setup. 1.
Connect Camera to wifi router 1. In LIVE view, tap the Back icon, the System icon, and then the System Settings icon. The System Information screen displays. 2. Tap Advanced. Enter the Admin password (123456). 3. Scroll to the option WiFi Setting on the Advanced Settings list. Tap Manage WiFi Network. Select your router from the drop-down list and enter your router’s password. Tap Connect. your camera will reboot and reconnect to the router.
Mounting the Plate and Camera 1. Hold the mounting plate where you want to mount it and mark the location of the screw holes. 2. Use the included screws and anchors to attach the mounting plate to the wall. 3. Use the enclosed screws to screw the camera to the bracket. Troubleshooting If... Try This... My smartphone or wireless device cannot find the camera during setup. Make sure the camera’s green LED is blinking in a 3-flash/pause pattern.
Networking Parameter Wireless Technology IEEE 802.11 b/g/n Network Connection Ethernet (10/100 Base-T/Base -TX); WiFi Simultaneous Viewers 3 concurrent sessions Security WPA /WPA2/WPA2-PSK (TKIP, 128 bit AES) Camera Parameter Image Sensor Mega pixel CMOS Local Storage Micro SD Card, Class 10 Viewing angle H:75°±3°, V45°±3° Min. Illumination 1~8 lux Number of LEDs 5 IR LEDs with IR switcher IR Distance 5~8 meters Video Audio Parameter Image Compression H.
one-year limited warranty Guardian App Cam 26 Important: Satisfactory evidence of the original purchase is required for warranty service. Please refer to our Uniden website for any details or warranty durations offered in addition to those contained below. Warrantor: The warrantor is Uniden Australia Pty Limited ABN 58 001 865 498 (“Uniden Aust”).
Statement of Remedy: If the Product is found not to conform to this warranty as stated above, the Warrantor, at its discretion, will either repair the defect or replace the Product without any charge for parts or service. This warranty does not include any reimbursement or payment of any consequential damages claimed to arise from a Product’s failure to comply with the warranty. Our goods come with guarantees that cannot be excluded under the Australian Consumer Law.
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.