User's Manual

IN THE BOX
Camera (1) Antenna (1) Stand (1) AC Power
Adapter (1)
Quick Connect
Guide (1)
Ethernet to
USB Cable (1)
Screw Pack (1)
SET UP CAMERA AND SMARTPHONE/TABLET
This Quick Connect Guide only shows images for Android devices. Images for iOS devices are
very similar.
PREREQUISITES
x Your router must support WEP/WPA/WPA2 security and it must be turned on.
x You must have an available WiFi-enabled mobile device (Android or iOS smartphone/tablet).
x The AppCam and your mobile device must connect to the same Wi-Fi router for setup.
1. Download the Uniden® AppCam™ app from the Apple iTunes
store (iOS) or Google Play (Android) onto your device.
2. Connect the antenna to the camera. You can attach the camera stand to the camera as
well but it is not necessary. Procedures for mounting the AppCam 25HD and attaching
the camera are provided later in this Quick Connect Guide.
3. Connect the camera to power After about 45 seconds, the red LED is steady on and the
green LED begins to flash (3-flash/pause pattern).
A
PPCAM25HDA
QUICK START GUIDE
Use this Quick Connect Guide to connect
the camera on the network. If you want
to set up more cameras later, refer to the
online user manual for instructions.
2. Select your time zone. The most commonly used time zones are:
ͳ GMT-05:00 - Eastern Standard
ͳ GMT-06:00 - Central Standar
ͳ GMT-07:00 - Mountain Standard
ͳ GMT-08:00 - Pacific Standard
ͳ GMT-09:00 - Yukon Standard
ͳ GMT-10:00 - Alaska-Hawaii Standard
3. Set the Daylight Savings Time indicator.
4. Tap Back, and exit the Advanced Settings list.
For complete operation instructions, refer to the online user
manual at www.uniden.com
TROUBLESHOOTING
If ... TRY THIS ...
My smartphone or
wireless device cannot
find the camera during
setup.
Make sure the camera’s green LED is blinking in a 3-flash/pause
pattern. If it isn’t, reset the camera by pressing and holding the
Reset button on the cord until the LEDs begin to flash.
The app cannot find the
camera
- Make sure your network supports DHCP protocol.
- Make sure that the DHCP option is turned on.
- Make sure the camera and your mobile device connect to the
same WiFi router.
- Make sure the WiFi router is activated.
- Make sure the camera is properly powered on.
- Make sure the WiFi router has enabled SSID broadcasting.
The camera does not find
the router to connect to
- Make sure you selected the correct router in the Manage WiFi
Network box.
- Make sure you entered the correct password for the router you
selected in the Manage WiFi Network box.