APPCAM21 1
CAMERA OVERVIEW 2
KIT CONTENT 3
Quick Start Guide 1. Run APK file to install the APP to your mobile device, then ”Click “OMGuard Lite” on mobile desktop to run the APP, as showed below 2.
3. There are 3 ways for IP cam connection setup. But for 1st time installation of your IP cam, we need to setup the connection between IP cam and your router by entering SSID and PW of your router to the IP CAM for Wi-Fi connection. Therefore, please select “AP Wizard add” option to proceed with the setup 4.
5. Click “Next” 6.
. IP CAM’s SSS ID will be shown as “IIPCAM_XXXXX” , Please select this SSID for direct connection, then and enter PW “88888888” to establish the link (“88888888” is the default password) 8. Upon Connection enter ID/PW to continue; the default ID is “admin”, no need to enter any PW (Blank).
9. Select the router you are going to use and enter the router password. 10. NOW, the IP camera will reboot to save changes, so please wait for about a minute; if the green LED turns steady on, it means the IP cam has connected to the router successfully (Note: pairing will be finished when the indicator stays on in green light).
11. Now, you need to change the Wi-Fi connection back to your router, after change the Wi-Fi connection, Click “Next” to continuous 12. Now a new Cam setup window will show up, the default name is “IPC-XXXXXXXXXXXX”.
13. The camera will be shown on the list. Click on the Icon to viewing and control other function of the IP Cam. 14.
15. You can click “tool” (as below RED area) for enter, edit, or delete this camera. 16. If you would like to playback the previous recorded video or photos, please click “Gallery” at the bottom menu ※IP Cam reset: Press “reset” for 10 sec. till the green light is off. Then Press “reset” again till the green light is on.
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
