User's Manual

JB
101
User Manual
Access
ories included with your product
Rubber stand Cable Tie
2.
Magnet alignment mark2. Magnet alignment mark
1. LED indicator1. LED indicator
3. Cable tie through hole 3. Cable tie through hole
5. Rubber stand5. Rubber stand
4. Battery ribbon4. Battery ribbon
Ins
tall JB101 on your Bike
Step
1
:
Place sensor on left chainstay with 2 cable tie
Let Logo side outwards
Step2
:
Insert the pointed end of the cable into the
locking piece, Keep cable loose to allow some
adjustment of position and tilt angle.
Step
5:
Til
t the JB101 sensor top side closer to magnet within 5mm for
better sensing performance
Step
6
:
Sw
ing rear wheel ,let the magnet pass through JB101 if LED turn
on sequentially. Then tighten 2 cable tie and cut off redundant
cable to finish hardware installation
5mm5mm
Speed Meter
Install Battery
Step
1
:
Remove JB101 rubber stand
Step 2
:
pull out battery Ribbon
Step
3:
batt
ery push into battery
holder
Step
4
: LED will flashing , if battery is install
correct
Step
6
:
Push back the battery ribbon
and covered with Rubber stand
Note
: The
battery Anode mark should
face to Logo, same direction
as icon on bottom side of JB101
Step
3
: Mount the Magnet on the spoke, place the
spoke in the groove of the plastic piece
Step4: Move magnet to align triangle mark on JB101 ,
tight the screw to fix magnet position.
No
te:
place JB101 on chainstay close to the Rim