Installation Instructions

ManualsBrandsJS International ManualsDecorative AccentsJSI 30"W x 36"H White Framed Mirror

Vanity Cabinet

Assembly Instructions

This assembly instruction applies to VJ-V4821D, VK-V4821D, VD-V4821D, VS-V4821D,

485 Commerce Dr.

Fall River, MA 02720

Parts included:

Cabinet Items

Qty

A Face Frame with Door

1 x

Side Panel

(Left and Right)

2 x

C Bottom Panel

1 x

D Back Panel

1 x

E Toe Kick

1 x

F Drawer Front

4 x

Tools needed for assembly:

Drawer Items

Qty

I Drawer rails

8 x

Drawer rail

Holder

8 x

K Drawer Box

4 x

½” Flat Head

Screws

12 x

1/2'' Rail Boot

Screws

24 x

1'' Drawer

Bottom

Screws

12 x

Flat and Philips screwdriver

Summary of content (5 pages)

PAGE 1
485 Commerce Dr.
PAGE 2
Step #1: Check & Count Check and count the items in the box before installation. If you are short any pieces, stop and call your supplier. Otherwise, follow the steps below. Step #2: Set-up A Put the face frame (A) face down on a flat soft working surface (Figure 1). Use screw driver to screw the cam lock pins (P) in the pre-drilled holes on the frame.
PAGE 3
Step #4: Install Bottom Panel Install the bottom panel (Figure 4): Gently spread side panels and insert bottom panel (C) into the grooves of side panels (B) until it touches the face frame (A). B B A Figure 4 Step #5: Install Back Panel & Toe Kick D Install the back panel and toe kick (Figure 5): Install the Back Panel. Put the back panel (D) at rear of side panel (B). Align it with the top of the side panels and lock each cam lock (Figure 5).
PAGE 4
Step #7: Drawer Assembly Drawer assembly: There are 4 predrilled holes on the drawer box (G), align them with the predrilled holes (Figure 7) on the drawer front (F) and fasten the drawer front to the drawer box using the 1” drawer box screws (N). G F Figure 7 Step #8: To install the drawer rails, first separate inner rail from outer rail by pulling the drawer glide to the open position. Then push on the black plastic locking mechanism.
PAGE 5
Step # 11: Install outer rail to the cabinet frame by pushing the rails into the drawer rail holder. Use one flat head screw (L) to fasten the front end of the rail to the face frame (Figure 12) Figure 11 Step# 12: Drawer Assembly Gently slide the drawer box into the outer rail.