Operating Instructions

ManualsBrandsJRL ManualsElectronicsremote control

Remote Operating Instructions

1. Remote Controller

RF Remote control,long distance,mini size,wire connection is simple and very easy to use;

Functions Of Each Button:

Usages:

Model usage

Pressing the model button to select the lighting movement model you want. Currently LED have below 6 models:

1. Multi-colour lighting twinkle consistently 2. single color lighting twinkle consistently (total 7 colors) 3. Mult-color light

move consistently 4. Single color light move consistently (total 7 single color) 5. Multi-color lighting move discontinuously

6. Single color lighting move discontinuously.

Speed usage

Continuously pressing the speed up or down button untill the speed you want.

Matching

Continuously pressing the MATCH button 5 times until LED flash in white quickly to match the Remote control with the

receiving controller.Pressing the MATCH button for 5 times till LED flash in white slowly to un-match;

Reorder RGB

Differ from kinds of LED, The R G B keys may don’t perfectly match to your LED, Reorder them if needed. Continuously pressing

the SETTING button 5 times until LED flash in white once and then turn into all white,Pressing the R button until LED is red, Pressing

the G button until LED is green, pressing the B button till LED is blue, then press the SETTING button once to confirm your setting;

2. Receiving Controller：

● The receiver controller working voltage :5V—24V-supply-voltage;

Cautions: Please make sure the power supply voltage is match to your controller before you power it.

Warning

This product contains a Button battery. If swallowed, it could cause severe injury or death in just 2 hours. Seek medical attention

immediately.

Always purchase the correct size and grade of battery most suitable for the intended use.

Replace all batteries of a set at the same time.

Clean the battery contacts and also those of the device prior to battery installation.

Ensure the batteries are installed correctly with regard to polarity (+and -).

Remove batteries from equipment which is not to be used for an extended period of time.

Remove used batteries promptly.

FCC Regulatory Compliance

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may

not cause harmful interference, and (2) this device must accept any interference received, including interference that may

cause undesired operation.

Warning: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to

operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a

particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment

off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.

ON/OFF

AUTO

SPEE

DOWN

MODE

DOWN

BRIGHTNES

S UP

BRIGHTNES

S DOWN

MATCH

SETTING

RED

GREEN

BLUE

WHITE

YELLOW

CYAN

PURPLE