LoRa® TEMP’ Ref : 12628 January 2020 USER GUIDE
TABLE OF CONTENTS I. INTRODUCTION ..................................................................................................................................... 3 a) Box contents .............................................................................................................................................................. 3 b) Symbols ......................................................................................................................................................
I. INTRODUCTION The LoRa® TEMP’ is a temperature indicator measuring temperature and transmitting data wirelessly to a web platform using the LoRa® long-distance network. The LoRa® TEMP’ complies with the ISO EN 13485 standard a) Box contents b) 1 LoRa® TEMP’ 1 battery 1 wall mounting device 1 user guide Symbols RECYCLING: electrical items should be disposed of separately from household waste.
II. INSTALLATION RECOMMANDATIONS The LoRa® TEMP’ is a temperature indicator communicating in radio frequency with software hosted on a web platform via the public LoRa® long distance network or via a private gateway.
III.
IV. USE When you receive the LoRa® TEMP’ it is turned off: it can neither send nor receive data. a) Device activation To activate the LoRa® TEMP’ press and hold the On/Off button for more than 3 seconds. Once the device has been activated it starts measuring and transmitting data to MySirius at the set intervals. >3’’ b) Note: The LED lights up when the minimum press time is reached, allowing you to know when to release the On/Off button.
V. BATTERY REPLACEMENT a) Removal of the battery Lift the back panel off ❶ Remove the grid ❷ Take the battery ❸ out of its compartment. b) Installation of the new battery Insert the new battery ❸ into the battery compartment and make sure that it is properly aligned. Put the grid back ❷ Put the back panel back ❶ Battery detection is confirmed by the activation of the LED for a couple of seconds. The device can be switched on when the LED stops flashing.
VI. CHARACRERISTICS LoRa® TEMP’ - (internal probe) HMI : 1 white LED + 1 push button Communication : CE frequency: 867.1-867.9MHz, 868.1-868.5MHz Memory Sensor : 100 time-stamped measurements Operating range : -30+70°C Measurement range : -30+70°C Storage temperature Accuracy : -40+85°C : ±0.5°C from 0°C to +25°C / ±1°C from -20°C to 0°C and from +25°C to +70°C / ±2°C from -30°C to -20°C Resolution : 0.
VII. CLEANING Clean the device with a soft, dry or sligthly damp cloth. To remove stubborn stains, use a cloth soaked with a mild non-abrasive detergent solution, then wipe the surface with a soft, dry cloth. Don't use benzene, thinners, alcohol or other types of solvents which might damage the finish. VIII. GUARANTEE Our products carry a one-year guarantee against manufacturing defects, malfunction, or abnormal wear.
X. ENVIRONMENTAL PROTECTION JRI recommends to dispose unusable and/or irreparable measurement and recording materials in a manner compatible with the protection of the environment. As the production of waste materials cannot be avoided, these should be reused through the recycling process best adapted to the concerned materials and to the protection of the environment.