Users Manual

E6850 CONNECT WIRELESS HEARING PROTECTOR

featuring Bluetooth wireless technology

Basic Operation

Charging the Headset:

Your hearing protector has been shipped to you with only a partial

charge on its integrated lithium ion battery pack. To charge the hearing

protector, insert the supplied Type-C connector cable into the Type-C

jack located on the bottom of the right cup of the hearing protector.

Connect the other end of the cable to a suitable USB power source

such as a computer or third party certified (UL, Intertek, etc.) AC to

USB wall adapter.

The LED will be blink blue while charging and change to solid blue

when complete.

Fitting the Headset:

Fully extend sliders and place cups over ears.

Then, tighten headband using sliders.

Power：

Press and hold power button for 2 seconds to power ON/OFF headset.

Low Battery Warning:

Hearing protector will also provide a “Battery Low” warning by bleeping voice

when battery voltage is low.

Auto Shut-Off:

5 minutes after either Bluetooth or the audio input is disconnected, the hearing

protector will automatically power down. After auto shut-off, press and hold the

ON/OFF button for 3 seconds to turn back on.

PAGE 1
E6850 CONNECT WIRELESS HEARING PROTECTOR featuring Bluetooth wireless technology Basic Operation Charging the Headset: Your hearing protector has been shipped to you with only a partial charge on its integrated lithium ion battery pack. To charge the hearing protector, insert the supplied Type-C connector cable into the Type-C jack located on the bottom of the right cup of the hearing protector.
PAGE 2
Bluetooth Operation Pairing the Device: Once powered on, the LED will be blink blue. Make sure your Bluetooth enabled device is scanning/searching for devices. Check your device to make sure it has discovered “E6850” Select “E6850” to connect to the hearing protector. Once connected successfully, the LED on the right cup will turn blue. Your Bluetooth audio volume will be controlled by your device.
PAGE 3
FCC Caution： This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.