§ Holder Charger/Digital Transmitter for iPod§ ST-31 User’s Manual
◆ Features: l l l l l l l l l Input Voltage: DC+12V ~ +16V. Current : 2A﹝ Max.﹞ . Output RF range: 88.1 MHz ~ 107.9 MHz. [76 MHz ~ 90 MHz. for Japan Version] Radio Frequency Adjustment: 0.1MHz / Per step. Radio Frequency Response: 5.Hz ~ 20KHz. LCD ”Digital Display” on FM Transmitter. iPod Charging Function. Compatible with iPod 10G, 15G, 20G, 30G, 40G and iPod mini 3G. Extension Power Plug available for mobile with cigarette lighter in lower position. ◆ Contents: Figure 1 1. Holder/Transmitter Base 3.
◆ Holder Installation Instruction & Notes: For iPod 10G, 15G, 20G, 30G1. Install iPod to the Holder for iPod 2. Note: Attached Protection Pads can be used to compatible with iPod 10G, 15G, 20G. As Figure 2. Figure 2. 2. Install the iPod & holder 2 to the Holder/Transmitter Base 1. As Figure 3 & 5. For iPod mini 3G – 1. 2. 3. Install iPod mini to the Original Apple Belt Clip Holder (no included in this package). Install the Holder and iPod to the Clip for iPod mini Holder 4. As Figure 4.
◆ Power Plug Installation Instruction & Notes: 1. Insert power plug3 into Holder/Transmitter base 1 and twist gently clockwise to “on” (on the back of Holder/Transmitter base.) As Figure 6. Figure 6. If the car’ s cigarette lighter or the set of Holder/Transmitter base is too low or too close to the gear shifter, use extension stick2. Insert the extension stick2 into Transmitter1 by twisting gently clockwise to “on” (on the back of Holder/Transmitter base.
◆ Using the FM Digital Transmitter (first time usage): Figure 8. 1. Connect the FM Transmitter to the Holder/Transmitter base. Press (Quick Key o) of the FM transmitter, the ”LCD Digital Display” will show out flash OK letters, around 3~5 seconds, as Figure 9. Figure 9. 2. Then ”LCD Digital Display” shows out the pre-set radio frequency channel ﹝ 88.1MHz﹞ , as Figure 10.
l 6. If the radio does not become mute, re-check and make sure the radio frequency channel of the FM Digital Transmitter and the radio is the same. ) Press and hold (Quick Key o ) of the FM transmitter around 2~3 seconds, the ”LCD Digital Display” will show out - - - - letters and then power off, as Figure 11. Figure 11. 7. Then display the iPod music through the radio. 8. Adjust the volume through your radio until the satisfactory output is reached. 9. Set up the radio frequency channels once.
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.