a module solution provider WG1300-00 EM Board User Guide Revision 0.1 Copyright © JORJIN TECHNOLOGIES INC. 2012 http://WWW.JORJIN.COM.
Doc No: WG1300-00 EM Board-UG-D01 Index 1. INTRODUCTION…………………………………………………………………1 2. WG1300-00 EM BOARD ........................................................................................ 2 2.1. TOP SIDE ............................................................................................................. 2 2.2. BOTTOM SIDE .................................................................................................... 5 2.3. Hardware setup…………………………………………………………………7 2.4.
Doc No: WG1300-00 EM Board-UG-D01 1. INTRODUCTION The purpose of this user guide is to help user understanding how to use WG1300-00 EM (Evaluation Module) board to complete hardware setup for test to evaluate the performances of CC3000-WG1300-00 SiP Module. 2. WG1300-00 EM BOARD In the following sub-sections, it’ll divide into TOP and BOTTOM Side to explain details on the key parts and its features. 2.1. TOP Side Figure 1 is TOP-Side picture of WG1300-00 EM Board.
Doc No: WG1300-00 EM Board-UG-D01 Items Key Parts Descriptions The core module for performance evaluation. It’s 1 CC3000-WG1300-00 related feature can be referred to its datasheet. Module 2 Antenna It can used for radiated test by reworking cpacitor to correct pads. 3 J1 It’s a U.FL RF connector via which you can proceed conducted power test. It is a jumper via which we can swap testing modes, test mode and operation mode.
Doc No: WG1300-00 EM Board-UG-D01 for normal operation 7 GND Ground 8 WL_SPI_CS I Host interface SPI Chip Select 9 WL_SPI_DOUT O Host interface SPI Data Ouput 10 WL_SPI_IRQ O Host Interface SPI Interrupt Request 11 WL_SPI_DIN I Host Interface SPI Data Input 12 WL_SPI_CLK I Host interface SPI Clock input Table 2. TOP-Side J4 of WG1300-00 EM Board Table 3 below shows the signal descriptions of J5 Pin Number Pin Name Pin Type Descriptions I2C Clock signal output from CC3000.
Doc No: WG1300-00 EM Board-UG-D01 Battery voltages’, R14 can be remove to support such a case. Battery voltage input to Module. For MSP430 Host platform, VIO_HOST=VBAT_IN. 9 VBAT_IN PI For other platforms which have different voltage levels from Battery voltages’, R14 can be remove to support such a case. 10 GND Ground External Slow Clock input from Host 11 EXT_32KHz I device. It can be used for the SiP Module inside which hasn’t slow clock source. Table 3. TOP-Side J5 of WG1300-00 EM Board 2.2.
Doc No: WG1300-00 EM Board-UG-D01 signals brought out from these two EM mating connectors. J6 Pin Pin Name Module Pin Type Description Number 1 GND Ground External Slow Clock input from Host 5 EXT_32KHz I device. It can be used for the SiP Module inside which hasn’t slow clock source. 10 VBAT_SW_EN I Active-high enable signal from Host device.
Doc No: WG1300-00 EM Board-UG-D01 2.3. Hardware Setup Before conducting performance test, EM Board should be connected to Host platform, either with mating connectors, J6 and J7, or single row headers, J4 and J5. For the case of using EM mating connector for hardware connection, the mating EM connector should be lined up and spaced 1.2” apart as Figure 3 below Figure 3.
Doc No: WG1300-00 EM Board-UG-D01 2.4. Schematics Figure 4 is the schematics of WG1300-00 EM Board WG1300-00 Module VBAT_IN: 2.7V~4.8V => 3.3V TYP VIO_HOST: Voltage of Host Level (1.2V~3.
Doc No: WG1300-00 EM Board-UG-D01 2.5. Bill Of Material (BOM) Items Reference Designator Description 1 U1 TI CC3000 WiFi b/g Module (BM) 2 ANT1 ANT / 2.4GHZ / Peak Gain 2.5DB 3 J1 Mini RF Header Receptacle 4 J2 CON Male 1x3 / Pitch 2.0 mm 5 J3 CON Male 1x2 / Pitch 2.0 mm 6 J6,J7 7 C1,C3 CAP 0402 / 10pF / 50V / NPO / ±5% 8 C4,C5 CAP 0402 / 1uF / X5R / 6.3V / ±10% / HF Female Header / Fool Proof H:4.3 / 2x10 / Pitch 1.
Doc No: WG1300-00 EM Board-UG-D01 3. APPLICATION DEVELOPMENT Texas Instrument had developed a HOST platform, MSP-EXP430FR5730, for evaluating CC3000-based SiP Module. Figure 4 shows the platform and WG1300-00 EM Board Figure 4. MSP-EXP430FR5730 and WG1300-00 EM Board The MSP-EXP430FR5739 test platform can be ordered as the link below. http://www.ti.com/tool/msp-exp430fr5739 Specific application examples can refer to the link below http://processors.wiki.ti.com/index.
Doc No: WG1300-00 EM Board-UG-D01 4. HISTORY CHANGE Revision Date Description R 0.1 Release 0.1 2012/2/28 Copyright © JORJIN TECHNOLOGIES INC. 2012 http://WWW.JORJIN.COM.
