User's Manual

Re: JCI Bluetooth Transceiver
USER'S MANUAL INFORMATION
The device under test is manufactured by the grantee (JCI) and sold as an OEM product.
Per 47 CFR 2.909, 2.927, 2.931, 2.1033, 15.15(b) etc…, the grantee must ensure the end-
user has all applicable / appropriate operating instructions. When end-user instructions
are required, as in the case of this product, the grantee must notify the OEM to notify the
end-user. JCI will supply the following information to the reseller/distributor dictating
what must be included in the end user’s manual for the commercial product.
INFORMATION TO BE INCLUDED IN THE END USER'S MANUAL
The following paragraphs (in red) must be included in the end product user’s manual to
ensure continued FCC and Industry Canada regulatory compliance.
************************************************************************
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry
Canada. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressively approved by the party responsible for
compliance could void the user's authority to operate the equipment.
************************************************************************
It is preferred that the following ID numbers (in red) be included in the manual if the
device label is not readily accessible to the end user.
************************************************************************
FCC ID:CB2BLUEC08
IC: 279B-BLUEC08
************************************************************************
The following information (in red) should be provided to the end user, regardless of
placement of the device (portable vs. installed in vehicle) by citation in the manual.
Please note that co-location is generally considered to be when 2 transmitters radiating
elements are < 20 cm apart from each other.
************************************************************************
The antenna used for this transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter. End-users and installers must be provided with
installation instructions and transmitter operating conditions for satisfying RF exposure
compliance.