Ditto Projector DT01 New calibration steps for ditto projector and workspace quick start
Connection steps Navigate to open one pattern in workspace.
Connection steps IF Succeed User will be advanced to optional calibration pop-up below Projection IF FAILED User will be notified what went wrong Be sure to capture all four corners of the projection in your photo Nottingham Spirk | Prepared for JOANN Projection CONFIDENTIAL Not To Be Shared 3
Step 1 Make sure projector has power Setup projection stay projected until app is connected to ditto projector • Make sure the room is dimly lit showing the projected frame as vivid red.
Step 2 Make sure projector is connected to the app.
Step 3 • Then, when the camera is launched within the app, take a photo of the entire calibration projection. It is best to stand opposite table side to the beam and hold the device up high. (TIP: make sure camera at eye level not up too high shooting down) • Be sure to capture all four corners of the projection in your photo. Be sure your fingers or anything else does NOT obstruct the photo view.
Step 4 Processing of image takes a couple second No Projection on mat If succuss, there will be a confirmation, see next page Projection Nottingham Spirk | Prepared for JOANN CONFIDENTIAL Not To Be Shared 7
Step 5 • Calibration confirmation projection will be displayed after the photo is processed for confirming successful calibration, please confirm the lighted squares are within the white squares on the cutting mat.
Done User closes success pop-up to go back the workspace No Projection on mat IF FAILED If failed, there will be a pop-up showing the error Projection Nottingham Spirk | Prepared for JOANN CONFIDENTIAL Not To Be Shared 9
Workspace The ditto workspace is the area where pattern pieces are arranged for projection • To add a pattern piece to the workspace, long press it and drag it over • You can place and project multiple NON-spliced pieces into the workspace at the same time (demonstrate this – many research participants thought they could only project one piece at a time) • Next to each pattern piece is a check box to keep track of what’s been cut • The Reference Layout at the top right allows you to select a layout to follo
FCC Warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.