Quick Instructions

ManualsBrandsJMGO ManualsElectronicsBLUETOOTH REMOTE CONTROL

BLUETOOTH REMOTE CONTROL

Quick Instructions

You need to perform Bluetooth pairing to enable the voice function.

Use the remote control【power key】 to turn on the projector.

Bluetooth pairing

When the projector is turned on to enter the system, press and hold the [Shortcut Center Key] and [Settings Key] on the remote control at the

same time for more than 2 seconds.

When the indicator light starts to flash, it enters the pairing mode, and the remote control will automatically pair and connect. After the pairing is successful,

the system interface will have a corresponding prompt.

If the indicator light goes out and there is no prompt, the pairing fails and you need to pair again.

After the Bluetooth pairing is successful, you can use the voice function.

After successfully pairing, turn on the projector again without repeating pairing, it will automatically pair. If it fails to automatically pair or replace the

projector, you need to manually perform the pairing operation again.

Summary of content (4 pages)

PAGE 1
BLUETOOTH REMOTE CONTROL Quick Instructions You need to perform Bluetooth pairing to enable the voice function. Use the remote control【power key】 to turn on the projector. Bluetooth pairing When the projector is turned on to enter the system, press and hold the [Shortcut Center Key] and [Settings Key] on the remote control at the same time for more than 2 seconds. When the indicator light starts to flash, it enters the pairing mode, and the remote control will automatically pair and connect.
PAGE 2
LED indicator display. Touch the button and the LED light will turn on. Long press the button, the LED light keeps on. When pairing, the LED light flashes for 0.5 seconds, the pairing successful LED is always on for 2 seconds, and the pairing timeout indicator is off. When the battery level is less than 10%, the indicator light flashes twice at an interval of 1.5 seconds, and flashes cyclically, with an interval of 0.5 seconds. When charging, the LED light is a breathing light effect.
PAGE 3
FCC statement This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
PAGE 4
IC The licensed transmitter/receiver contained in this device is compliant with Innovation, Science and Economic Development Canada's RNC for licensed radio devices.The operation is permitted under two conditions: 1. The device must not cause interference; 2. The device must accept any radio interference, even if the interference is likely to compromise its operation. RF exhibition statement: The equipment complies with the IC radiation exposure limit established for an uncontrolled environment.