Product Manual

1
ESP-M1/M2
product manual
Ver V1.0
Fentures
■ SOC characteristics Peripheral for Module
● Built-in Tensilica L106 ultra-low power ● 2*UART
Consumption 32-bit cpu, the main frequency ● 1*En;
Can be 80MHz and 160MHz, also support ● 1*ADC;
RTOS; ● 1*wakeup pin;
● Built-in TCP/IP protocol stack; ● 1*HSPI;
● Built-in 1 channel 10-bit high precision ADC; ● 1*I2C;
● The outeide interfaces have HSPI, UART,I2C, ● 1*I2S;
I2S,IR Remote Control, PWM, GPIO; ● MAX 10* GPIOs;
● The deep-sleep current is about 10uA, and the ■ Working temperature:-40℃-125℃
Cut-off current is smaller than 5uA; ■ Module size:
● Can be wake-up within 2 ms, and connect to 12.3*mm*15mm;(M1 version)
Transmit data package; 12.3*mm*20mm;(M2 version)
● the consume power is smaller than 1.0mW Application
(DTIM3) when at standby status; ● Serial Transparent transmission;
● Built-in 1M byte for SPI Flash. ● WiFi prober;
● Smart power piug/Smart LED light;
■ Wi-FI characteristics ● Mesh networks;
● Sensor networks;
● Support 802.11 b/g/n/e/i ● Wearable electronics;
● Support three modes: Station, SoftAP, and ● Securit ID label;
SoftAP+STA; ● Wireless location recognition;
● Support Wi-Fi Direct(P2P); ● Wireless location system beacon;
● Support hardware acceleration for CCMP ● Industrial wireless control;
(CBC-MAC,computation mode),TKIP(MIC, Module Type
RC4), WAPI(SMS4), WEP(RC4), CRC;
● P2P find, P2P GO mode/GC mode and P2P Module Structure
Power management;