User's Manual

INSTRUCTIONS
2.Put 4 “AAA” size batteries into the robot and 2 “AAA” size batteries into the remote control as pictured.
3.Turn the red switch on the back of the robot to “ON”.Turn the red switch on the top of control to”ON”.
4.The robot is now ready for use.
Shake the right hand control,robot will give a right punch and a little right step.
Vice versa.
Shake two controls one at a time,robot will give punches while moving forward.
5.Do not shake the controller too fast which would make the robot disordered.
If the robot happen to make sound but without moving,pls shake&swing the equipment gently
6.Please do not play the robot at high place.
If the equipment fall down,its function will likely become disordered.
ATTENTION - FOR BEST RESULTS:
1.Please remove the batteries from the
robot and the remote control,
if the product will not be used for a long
period of time.
2.Please keep the product dry.
1.ALWAYS PURCHASE THE CORRECT SIZE AND GRADE
OF BATTERY MOST SUITABLE FOR INTENDED USE.
2.DO NOT MIX OLD & NEW BATTERIES,ALKALINE,
STANDARD(CARBON-ZINC) OR RECHARGEABLE
(NICKEL-CADMIUM) BATTERIES.
3.CLEAN THE BATTERY CONTACTS AND ALSO THOSE
OF THE DEVICE PRIOR TO BATTERY INSTALLATION
4.ENSURE THE BATTERIES ARE INSTALLED CORRECTLY
WITH THE REGARD TO POLARITY (+ AND -)
5.ALWAYS REMOVE BATTERIES IF CONSUMED OR IF
PRODUCT IS TO BE LEFT UNUSED FOR A LONG TIME.
FCC ID: 2AHGJJMSYZ120-49
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference.
(2) this device must accept any interference
received,including interfe ence that may cause
undesired operation.
Warning:Changers or modifications to this unit not expressly
approved by the party responsible for the compliance could void
the user’s authority to operate the equipment.
NOTE:This equipment has been tested and found to comply
with the limits for a Class B digital device,pursuant to Part,
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates,uses and
can radiate radio frequency energy and,if not installed and
used in accordance with the instructions,may cause harmful
interference to radio communications.
However,there is no guarantee that interference will not occur
in a particular installation.If this equipment dose cause
harmful interference to radio or television reception,which
can be determined by turning the equipment off and on,the
user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment the receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
PLS KEEP THESE INSTRUCTION FOR FUTURE REFERENCE
1.Requires 6 (Six) 1.5V AAA alkaline batteries (Not included).
”
A
A
A
“
V5.1
”
A
A
A
“
V5.1
”
AA
A
“
V
5
.
1
”AA
A
“V5.1
”
AA
A
“
V
5
.
1
”AA
A
“
V
5.
1
for 20-30times and the robot will be working fine.
FCC ID: 2AHGJJMSYZ120-49
FCC ID: 2AHGJJMSYZ120-491
FCC ID: 2AHGJJMSYZ120-491