Installation Instructions for M-MCPv3-1.315 • M-MCPv3-1.660 • M-MCPv3-1.900 M-MCPv3-2.000 • M-MCPv3-2.250 M-MCPv3-2.375 • M-MCPv3-2.
1A 1B OR There are two speaker cable routing options. For applications where the cable cannot be routed through the pipe, the cable can be passed through one of the openings on the side of the fixture. 2 Determine the speaker mounting location, and temporarily secure the two fixture halves around the pipe by hand tightening the four 1/4 - 20 x 1-1/4” machine screws.
4 Apply Loctite® red thread-locking compound (included) to two 5/16 - 18 x 1-1/4” machine screws (included), thread them into the lower half of the fixture, and push down on the fixture to ensure no gap while fully tightnening. 6 Slide the excess speaker cable and the butt connectors into the opening in the pipe as you raise the enclosure to flush the fixture to the pipe. 5 Have a helper support the enclosure during this step.
8 Adjust the yaw angle of the enclosure and fixture assembly to the desired position. 10 Remove adhesive backing and install the JL Audio logo badge (Sport Grille Models Only). 9 Remove one of the 1/4 - 20 x 1-1/4” machine screws at a time. Apply Loctite® red thread-locking compound (included), reinstall, and fully tighten. Repeat the same process for the other three screws. 11 If a different speaker angle is desired, remove the speaker mounting screws and washers.
12 Rotate the speaker to the desired angle. Reinstall the speaker and speaker mounting screws and washers. Hand-tighten the screws in a criss-cross pattern. 14 Align the aluminum logo cap to the desired angle of rotation, and press it onto the back of the enclosure. Apply masking tape (not included) to hold the cap in place until the silicone cures (at least 24 hours).
FLEXIBLE MOUNTING OPTIONS Horizontal Mounting Vertical Mounting NOTE: The M-MCPv3-2.200 fixture and M770-ETXv3-SG-WH Enclosed Speaker System are used in this manual for illustrative purposes only. The fixture installation steps are the same for all ETXv3 Enclosed Speaker Systems and all M-MCPv3- Fixed-Mount Fixtures listed on front cover.
LIMITED WARRANTY - MARINE PRODUCTS (USA) JL AUDIO warrants this product to be free of defects in materials and workmanship for a period of two (2) years from the original date of purchase. This warranty is not transferable and applies only to the original purchaser from an authorized JL AUDIO dealer.
