QuickTap Telephone Handset Tap User Guide JK Audio
Connection Install QuickTap between the handset and the telephone base of your existing telephone. 1. Unplug the handset cord from your telephone base. 2. Using the black handset jumper cord that we have provided, connect the telephone jack of QuickTap to the handset jack on your telephone base. 3. Plug your handset cord, and handset, into the handset jack on QuickTap. 4. Connect your audio equipment to the line output jack on QuickTap.
Operation The Output Jack provides a mix of both sides of the conversation. In other words, whatever you send down the phone line will come back on this jack mixed with the audio from the other side of the call. Two adapter cables are supplied with the QuickTap. One cable has 1/8" mono connectors on each end. This cable can be used to connect QuickTap to the line input on some powered speakers. The second cord has a 1/8" stereo plug on one end and an RCA mono plug on the other end.
FAQ’s ? ! Will the QuickTap work with my telephone? The QuickTap will work with virtually any telephone that is not cellular and does not have a keypad in the handset. It is compatible with analog, digital, PBX, and ISDN telephones and systems. We cannot guarantee that it will work with every telephone out there, but we have yet to hear of one it does not work with.
Specifications Line Output Connector Output Impedance Output Level Isolation 1/8" Mono jack 600 ohms 100 mV RMS 1500 VRMS Handset and Telephone connectors: Modular 4pin/4wire handset jacks Compatibility Note: Not all telephones are built alike so we cannot guarantee QuickTap will work with any handset design out there. We designed QuickTap to work with most popular telephones. QuickTap is not for use with cellular phones or telephones that have a keypad built into the handset.
FCC Registration Your new JK Audio product has been registered with the Federal Communications Commission (FCC). This product complies with the standards in Part 68 of the FCC rules. The FCC requires us to provide the following information: 1. Connection and use with the nationwide telephone network The FCC requires that you connect this telephone equipment to the national telephone network through a FCC registered telephone. This equipment may not be used with Party Line Service or Coin Telephone Lines. 2.
FCC Registration (continued) Repairs to this telephone equipment can only be made by the manufacturer or its authorized agents or by others who may be authorized by the FCC. For repair procedures, follow the instructions outlined under the warranty section of the manual. 4. Rights of the telephone company If telephone equipment is causing harm to the network, the telephone company may temporarily discontinue your telephone service. If possible, they will notify you before they interrupt service.
Warranty The model QuickTap is covered by a 2 year warranty to be free from defective workmanship and materials. In the event that the QuickTap needs repair, you must call us to get an authorization, and then carefully pack and ship it to us. You will pay for shipping to us and we will pay for return back to you, UPS ground. No free repairs will be made if the defect was caused by misuse, weather conditions, or other cause, except for defective workmanship or materials.
