User Guide

FAQs
13
FAQs
ASCII Command Remote Control Cont’d
Command Name n Parameter / Description
/VBn(+) Verbose
Mode
n = 0
n = 1
n = 2
n = 3
n = +
OFF
LEVEL
LEVEL 2
MAX ON
Echo Off & Unsolicited Responses Off.
Echo Off & Abbrev. Responses Active.
Echo On & Expanded Responses Active.
Echo On & All Responses Active.
Turns On Line Termination Char ‘/’.
Unsolicited responses informing you of changes in call state will vary
depending on the verbose mode selected.
FAQs
1. Does the innkeeper 1rx send a burst or beep down
the phone line at the beginning of each call like our
current hybrid?
No. Innkeeper 1x uses the actual transmit signal to evaluate the phone line
and tune its algorithm. As you begin to speak, innkeeper 1x is hard at work
canceling your voice from the Caller Output jack. Within milliseconds your
voice is reduced into the noise oor.
2. Will your innkeeper 1rx provide phantom power for my
condenser microphone?
No, our devices will not provide phantom power. If you plan to connect your
microphone directly to an innkeeper 1x, you should use a dynamic mic.
3. Are there more ASCII commands I can send through the
serial cable or can I add my own?
The complete list of currently acceptable commands is listed on page 12.
4. Where is the software to control the serial port?
There is no software provided with the innkeeper 1rx. You will provide your
own terminal emulator, such as Hyper-Terminal.
5. How do I know what rmware my innkeeper 1rx is running on
and how can I update it?
Contact [e-mail] for possible rmware updates.