Installation Instructions
澽濡濤濣濦濨濕濢濨澔濇濕濚濙濨濭澔澽濢濚濣濦濡濕濨濝濣濢澔
澶濙濚濣濦濙澔濩濧濝濢濛澔濭濣濩濦澔濦濕濘濝濣澠澔濤濠濙濕濧濙澔濦濙濕濘澔濨濜濙濧濙澔濛濙濢濙濦濕濠澔濤濦濙濗濕濩濨濝濣濢濧澔濕濢濘澔濫濕濦濢濝濢濛濧澢澔
澔
濈濣澔濡濕濟濙澔濨濜濙澔濡濣濧濨澔濣濚澔濨濜濝濧澔濦濕濘濝濣澠澔濝濨澔濡濩濧濨澔濖濙澔濩濧濙濘澔濤濦濣濤濙濦濠濭澢澔
濄濠濙濕濧濙澔濦濙濕濘澔濨濜濙澔濝濢濧濨濕濠濠濕濨濝濣濢澔 濕濢濘澔濣濤濙濦濕濨濝濢濛澔濝濢濧濨濦濩濗濨濝濣濢濧澔濗濕濦濙濚濩濠濠濭澔 濖濙濚濣濦濙澔濩濧濝濢濛澔濨濜濙澔濦濕濘濝濣澢澔 濇濤濙濗濝濕濠澔
濕濨濨濙濢濨濝濣濢澔濡濩濧濨澔濖濙澔濤濕濝濘澔濨濣澔濨濜濙澔濋澵濆濂澽濂澻澔濕濢濘澔濂濃濈澽澷澹澔濧濨濕濨濙濡濙濢濨濧澔濝濢澔濨濜濝濧澔濡濕濢濩濕濠澢澔
Notice:
Use the two way radio in the environment with the temperature between 0-40ć,otherwise,it may damage your two way radio .
It can be operating under 2000m.
Hereby, Our declare that the radio equipment type two way radio is compliance with Directive 2014/53/EU.
For Adapter: Shall be installed near the equipment and shall be easily accessible.
For Battery: Risk of explosion battery is replaced by an incorrect type, dispose of used batteries according to the instructions.
For this device,Head SAR and Body SAR was performed with the device configured in the positions according to EN62209-2:2010,and face-up SAR was
performed with the device 25mm from the phantom,and Body SAR was performed with the device 0mm from the phantom. Body SAR was also
performed with the headset and belt clip attached and without.
FCC Statement
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation.
This device complies with Part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates and can radiate radio
frequency energy. If not installed and used in accordance with the instructions, it may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. Verification of harmful interference by this equipment to radio or
television reception can be determined by turning it off and then on. The user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
WARNING:
MODIFICATION OF THIS DEVICE TO RECEIVE CELLULAR RADIOTELEPHONE SERVICE SIGNALS IS PROHIBIITED UNDER FCC RULES AND FEDERRAL LAW.
Tx: 144-148/420-450Mhz
Rx:136-174/400-520/220-260
T/Rx:144-146/430-440Mhz
EU Version
222-225MHz
US Version
65-108MHz
AM Rx:108-136MHz