JME-7596C Wireless Keyboard JME-3272B USB Receiver User’s Guide
1 Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
2 - Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.
3 *Dispose of used batteries according to the instructions. *Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment R & TTE Compliance Statement This equipment complies with all the requirements of the DIRECTIVE 1999/5/EC OF THE EUROPEAN PARLIAMENT AND THE COUNCIL OF 9 March 1999 on radio equipment and telecommunication terminal equipment and the mutual recognition of their conformity (R & TTE).
4 1 2 Feature l Transmission mode: RF 2.4G l Frequency: 2400~2483MHz l RF channel quantity: 78 l Bandwidth of Channel: 1MHz l Data send timing: <500us l Keyboard power: 2 × AAA batteries l Receiver power: 5V l Modulation mode: GFSK l Effective distance: 10m l Number of keys: l Low battery indicating voltage:2.
5 n Plug the USB receiver into a computer’s USB port: □ Windows 98 SE/ME The system finds new device and prompts you to insert the operating system CD-ROM. Follow the instructions on the screen to install the required drivers. □ Windows 2000/XP/Vista/7 The operating system identifies the receiver as a “USB Human Interface Device” and begins installation automatically. When completed, the system will prompt that “You new hardware is installed and ready to use.
6 in the correct direction indicated by the AAA battery compartment label. n Replace the battery compartment cover. n Switch on the Keyboard. n Before first time of use, you need to connect the keyboard to the receiver as below: With the keyboard close to the receiver within 50cm and press the connect button. n In normal use, the led on the receiver blinks according to the wireless keyboard’s operation, if the keyboard and mouse are not in operation, the led is off.