User's Manual

JME-3263R user guide

1、

、、

、 Feature

1．1． Interface: USB 1.1

1．2． Power Input: DC 5V ±5% @ 100mA

1．3． Transmission mode：RF

1．4． Frequency：2400~2483.5MHz

1．5． RF channel quantity：77

1．6． Center of Channel: 2402/2403/2404…2476/2477/2478MHz

1．7． Channel Interval: 1MHz

1．8． Width of Channel: 1MHz

1．9． Data Rate: < 1Mbps

1．10． Receive Sensitivity: -93dBm

1．11． Data Send timing: <500us

1．12． Modulate mode：DSSS

1．13． Effective distance：10m

1．14． Operating Temperature: -5℃～45℃

2、

、、

、 Appearance draw（

（（

（Unit: mm）

））

）

3、

、、

、 Connector Spec

PAGE 1
JME-3263R user guide 1、、 Feature 1．1． Interface: USB 1.1 1．2． Power Input: DC 5V ±5% @ 100mA 1．3． Transmission mode：RF 1．4． Frequency：2400~2483.5MHz 1．5． RF channel quantity：77 1．6． Center of Channel: 2402/2403/2404…2476/2477/2478MHz 1．7． Channel Interval: 1MHz 1．8． Width of Channel: 1MHz 1．9． Data Rate: < 1Mbps 1．10． Receive Sensitivity: -93dBm 1．11． Data Send timing: <500us 1．12． Modulate mode：DSSS 1．13． Effective distance：10m 1．14． Operating Temperature: -5℃～45℃ 2、、 Appearance draw（（Unit: mm）） 0 .
PAGE 2
4、、 Pin Assignment Pin Number 1 Signal Name USB Vcc 2 USB D- 3 USB D+ 4 USB GND Connector 1 2 3 4 PCB 5、、 Use guide 2．1．First, confirm the receiver has been connected to the computer. 2．2．Put the batteries into the batteries casket, lock the cover. 2． 3．Press power button on left side of the keyboard to turn on power.
PAGE 3
The outside of the device into which the module is installed must also display a label referring to the inside module. This exterior label can use wording such as the following: “Contains Transmitter Module FCC ID: XYZMODEL1” or “Contains FCC ID: XYZMODEL1.” “XYZMODEL1” is the FCC ID number of this module .Any similar wording that expresses the same meaning may be used. The end products with this USB module mounted are subject to either DOC authorization or Part 15B certification.