WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE. TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, AND ANNOYING INTERFERENCE, USE THE RECOMMENDED ACCESSORIES ONLY.
For example, this unit may not have the capability to be connected to an outdoor antenna.
AC 120V~; eight (8) "C" size batteries (not included) 60Hz AC 120V~; 60Hz eight (8) "C" 7. Clean the batttery contacts and also those of the device prior to battery installation.
LOCATION OF CONTROLS 1. FM Telescope Antenna 1 2 2. Carry Handle 3. VOLUME Control Knob 4. Decorative LED Blinking Mode Selection (Turn Off) Button 11 5. M (Memory) Button 12 3 6. /BAND (Stop/Radio Band Selection) Button 4 13 7. (Skip/Fast Search Backward) Button 8. (Skip/Fast Search Forward) 5 6 7 8 9 10 14 Button 9. 15 16 /SCAN (Play - Pause/Radio Scan) Button 10. BT/CD (Bluetooth/CD Mode Selection) Button 11. CD Door 12. FINE TUNE (Radio Fine Tune) Knob 13. CD Door OPEN/CLOSE Area 14.
OPERATION RADIO: 1. Slide the Function Selector to RADIO position to turn on the radio. 2. Press the /BAND Button repeatedly to select AM or FM band as desire. The correspondence indicator AM or FM and the radio frequency will appear on the LCD Display. 3. Press and holding the or Buttons until the radio frequency on the LCD Display start running to automatically search and play the previous/next available radio station. Repeated the same procedures until the desired radio station is searched and play. 4.
3. Close the CD door by press the OPEN/CLOSE Area. Wait a few seconds; the number of the total tracks will appear on the LCD Display. 4. Press the /SCAN Button to start playback the first track on the disc. 5. During playback: Turn the VOLUME Control Knob to adjust volume level as desire. Press the /SCAN Button to pause; press again to resume normal playback Press the or Buttons repeatedly to skip the tracks. Press and holding the or Buttons to fast searching the specific section. 5.
BT (BLUETOOTH): BT pairing and play: First time use or re-pairing the unit to a new BT Device, pair as follows: 1.Slide the Function Selector to BT/CD/AUX position to turn on the CD. The LCD Display will illuminate and indicator “CD” will appear. 2.Press the BT/CD Button on the top of the unit to switch the unit from CD mode to BT mode: The Indicator on the front of unit will illuminate and blink. Indicate “bt” will appear on the LCD Display and blink. 3.
AUX (in): 1. Insert one end of the Audio Connect Cable (not included) to the AUX Out; Line Out or Phones Jack on the external Audio Player. 2. Insert the other end to the AUX (in) Jack on the left of unit. 3. Slide the Function Selector to BT/CD/AUX position to turn on the unit. The unit will automatically switch to AUX (In) mode. The LCD Display will illuminate and indicator “AUX” will appear. 4. Play the music on the connected external Audio Player as usual. 5.
TROUBLESHOOTING Check the following before requesting service: SYMPTOM POSSIBLE CAUSE AC Power cord had not connected No power POSSIBLE SOLUTION Connect the AC Cord to the rear of unit and any wall outlet having AC 120V~; 60Hz Volume of the unit was set to Increase the volume level by turning minimum position the VOLUME Control Knob clockwise No sound or sound weak Volume level of paired/connected Rise the volume level of the device is in low level paired/connected device Volume level too high Reduce the v