User's Manual

1. Inside the Box
2. Overview
3. Appearance
4. SIM card
5. Charging
6. Operations and functions
GPS tracker
Charger
Charging cable
User manual
Strong magnetic bracket(Optional)
GPS + LBS + WIFI positioning
Strong magnet installation
Sound alarm
SIM change alarm
Voice monitoring
Power (Red)
GSM (Green)
Status Meaning
Status Meaning
Flicker quickly GSM initialization
Flicker quickly
( every 0.3 seconds)
Low battery
Flicker slowly
( 0.1s on; 2s off)
Device is fully charged
/Work normally
Always ON Charging
Off
Device power off
/No battery/Sleep
Connect the device to the original charging connector
and charging cable.
2.1 Main Features
1). SIM should be inserted correctly.
2). SIM card should have GPRS service.
3). Please power off the device when you insert the
SIM card.
4.1 Insert the SIM card
6.1 Power on/off
6.2 APN setting
6.3 SOS number
4.2 LED Indication
2.2 Specifications
Frequency 850/900/1800/1900MHZ
Location Accuracy <10 meters
Monitoring range
Charging voltage/
current
≤5 meters
DC5V/500mA
Battery
MIC
LED
1 bio-color LED
Standby time
Dimension
65*30.5*18mm
Weight 61.5g (with magnetic cover)
1. Tracking mode (GPRS is
always connected,and GPS is
waked up by vibration)：≥14
hours
2. Sleep mode (GPRS is
always connected and GPS
sleeps)：≥7 days
LED
MIC
MIC
Charging contact
SIM card slot
On/Off button
Flicker slowly
( 0.1s on; 2s off)
Network is OK/On line
Off Device power off
1000mAh/3.7V industrial
grade Li-Polymer battery
1 MIC is for voice monitoring,
the other is for sound alarm
Note:
1. When device is turned on, LED will be off in 1 minute.
Momentarily press ON/OFF button to light up LED for 20
seconds.
2. In sleep mode, LED is off.
Hold and press the ON/OFF button for 3 seconds to
power/off the device.
Please send SMS command to the number of terminal
so as to set up the APN parameter. The terminal will
reply “OK” automatically after setting successfully.
Send SMS command: APN,APN name#
e.g: APN,internet#
NOTE:
The APN of some countries have user name and
password, you may need to send SMS command as
following:
(2) Delete SOS number
SOS,D,1,2,3# (D means delete SOS number)
e.g.
SOS,D,1# means delete the first number
SOS,D,3# means delete the third number
If you do not know the sequence number, you can also
delete the number by SMS command like this:
SOS,
D,number#
e.g. SOS , D , 13527852360# means delete this SOS
number directly.
It will reply “OK” if the number is deleted successfully.
(3) Query current SOS number
SOS#
You can set SOS number via the platform after the
device is activated.
(1) Add SOS number
You could set 3 SOS numbers in maximum. If set
successfully, the terminal will reply “OK”.
e.g. SOS,A,13510****60,135116****6,136126****8# (set
all 3 SOS numbers)
SOS,A,13510****60# (set the first SOS number)
SOS,A, ,135116****6# (set the second SOS number)
SOS,A, , ,136126****8# (set the third SOS number)
SOS,A,number1,number2,number3 #(A means add
number).
Send SMS command: APN,APN name,user name,
password#
e.g: APN,internet,CLIENTE,AMENA#
8.Tracking platform/APP
Please login tracking platform or APP of Android/IOS
authorized by distributor.
9.Trouble shooting
(2) Deep sleep mode
MODE,3,T1,T2#
T1 = Start time to wake up the device, format (HH:
MM), default start time 00:00;
T2 = Interval; range 1~72 hours, default 24 hours;
6.4 Voice monitoring
6.5 SIM change alarm
6.6 Record
Send SMS command MONITOR# by preset SOS number
to the device to monitor.
If the SIM card inserted has changed, the device would
send a SIM card change alert to the pre-set SOS
numbers.
SMS command: SIMALM,X,M#
X=ON/OFF; ON: turn on the alarm, OFF: Turn off the
alarm
M=0～1; alarm mode, 0: GPRS only, 1:SMS+GPRS,
M=2 GPRS+SMS+phone call; M=3 GPRS+phone call;
default: 1;
Send SMS command LY,A#by preset SOS number to
the device to record.
A means recording time, range: 10-300 seconds,
default: 60 seconds.
Query the current parameters: SIMALM#
6.7 Sound alarm
If the noise is above 60db, the device would send
alarm to the pre-set SOS numbers.
SMS command to set sound alarm:
SODALM,A,M,N,P,
Q#
A=ON/OFF; default value: OFF
7. Working mode setting
M=0~2; 0: GPRS+ automatic recording; 1: GPRS only:
2: GPRS+voice monitoring; default 2
N=Time for sound alarm triggered,the range is 1-10
seconds, Default: 3 seconds
P= Interval of sound alarms,ranging from 1-60 minutes.
Default: 2 minutes.
Q= Automatic recording time,ranging from 10-600
seconds. Default: 60 seconds.
(1) WIFI positioning mode & Positioning in a regular
time interval
SMS command: MODE,A,T#
A=1~2; 1: WIFI positioning mode; 2: Positioning
regularly mode; Default mode: 1;
T=10~86400; upload interval,unit: second; default:
600;
Query the current parameters: SODALM#
The following trouble shooting for your reference.
10. Caution & Notice
Maintenance Record
Fail to connect
to the network
Fail to check
location
Invalid
parameters
No reply
Check the SIM
card
Wipe with a
clean wiper.
SIM card installed
incorrectly
The sheet mental
of SIM card is
dusty
Damaged/Invalid
SIM card
Contact your
internet service
provider
Common
problems
Bad signal
Fail to
power on
Low battery Charging
Damaged SIM
card slot
Contact supplier
to replace SIM
card slot
Causes Solutions
Radio waves
cannot
communicate
with device when
it is used in a
bad signal area,
like basement or
space besides
tall building.
Put it in
somewhere with
good signal
Out of GSM
service area
SIM card has no
access to GPRS
service
Overdue SIM
card
Recharge
Please contact
SIM card sell
service to
activate GPRS
functions
Move back to the
GSM service
covered area.
Try again in a
strong signal area
Weak signal
Check network
and make sure
the SIM card has
SMS service
1. SOS number should be preset if you are willing to
receive alert message.
2. If put indoors or covered, the device may be unable
to locate, please take it to open field.
3. Use of the device in the fire or water is strongly
prohibited.
4. Do Not bend or disassemble the battery and the
device.
5. Please use the original battery. The warranty will be
invalid by using any other accessory. The
manufacturer will not take any responsibility for any
damage caused by not using the original battery.
6. For any questions, please contact the customer
service.
3. Warranty repairs must be carried out by our
Authorized Service Centre. Warranty cover will be
void, even if a repair has been attempted by any
unauthorized service centre.
4. Repair or replacement under the terms of this
warranty does not provide right to extension or
renewal of the warranty period.
5. The warranty is not applicable to cases other than
defects in material, design and workmanship.
Information to Users
According to the FCC Part 15.19, 15.21, and 15.105
rules, for this EUT, the instructions or operation manual
furnished the user shall include the following or similar
statement, placed in a prominent location in the text of
the manual:
FCC RF Exposure Information
and Statement
This device meets the government's requirements for
exposure to radio waves. The guidelines are based on
standards that were developed by independent scientific
organizations through periodic and thorough evaluation
of scientific studies. The standards include a substantial
safety margin designed to assure the safety of all
persons regardless of age or health. The SAR limit of
USA (FCC) is 1.6 W/kg averaged. Device types: Asset
GPS tracker (FCC ID: 2AMLFAT2 ) has also been
tested against this SAR limit. SAR information on this
and other pad can be viewed on‐line at
http://www.fcc.gov/oet/ea/fccid/. Please use the device
FCC ID number for search. This device was tested
simulation typical 10mm to body. To maintain compliance
with FCC RF exposure requirements, use accessories
should maintain a separation distance between the
user's bodies mentioned above, the use of belt clips,
Warranty Instructions and Service
1. The warranty is valid only when the warranty card is
properly completed, and upon presentation of the
proof of purchase consisting of original invoice
indicating the date of purchase, model and serial
No.of the product. We reserve the right to refuse
warranty if this information has been removed or
changed after the original purchase of the product
from the dealer.
2. Our obligations are limited to repair of the defect or
replacement the defective part or at its discretion
replacement of the product itself.
Date
Product
Model
IMEI
Number
Serviced by
Fault
Descript
ions
Comme
nts
Mini GPS Tracker
User Manual
(Version 1.1)
Please read this manual carefully before operation.
Pictures are for indication and illustration purposes
only.
holsters and similar accessories should not contain
metallic components in its assembly, the use of
accessories that do not satisfy these requirements may
not comply with FCC RF exposure requirements, and
should be avoided.
FCC Warning
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
NOTE 1: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
-Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV
technician for help.
NOTE 2: Any changes or modifications to this unit not
expressly approved by the party responsible for
compliance could void the user's authority to operate the
equipment.