User's Manual

The technical parameter and function description

Emergency button

Model:JD-EB30-A433/JD-EB30-A868s

Product Introduction:

It is an annular emergency button with the built-in wireless transmit signal

function. In the emergency situation, as long as you press the button, the

product will send a signal to the control panel to achieve an SOS alarm!

Function description:

1、 You need to register it with the control panel before using ;

2、When the button is pressed, the product's LED will light up and transmit

wireless alarm signal to the control panel. When the pressing time exceeds

2.2s, the button will stop sending the signal, only when you release the button

and then press again, the product will send the wireless signal again.

PAGE 1
The technical parameter and function description Emergency button Model:JD-EB30-A433/JD-EB30-A868s Product Introduction: It is an annular emergency button with the built-in wireless transmit signal function.
PAGE 2
3、If the battery voltage is below than 2.4V, when you press the button,the LED light will continuously flash to indicate that the battery needs to be replaced . Technical parameter: 1、Working Voltage:3V (Battery:CR2032) 2、Wireless Frequency: 433.92±0.5MHz 3、Transmit Current:≦20 mA 4、Static Current:≦0.
PAGE 3
Warning： This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.