User's Manual

computer radio control system

1. Switch off the transmitter and remove the 8 screws that secure

the radio back cover. Next, remove the radio back cover. Be sure

to disconnect the transmitter battery pack connector.

2. For ratchet tension adjustment use the machine screw “A”.

Turn slowly (counter-clockwise) until you achieve the desired

ratchet tension. For smooth tension adjustment, use the

machine screw “B”. Turn slowly (clockwise) until you achieve

the desired smooth tension.

4.3.4 Ratchet Tension Adjustment

Whether you prefer smooth throttle feel or ratchet throttle feel, you

can adjust the DS-16II transmitter either way you like allowing you to

fully customize your radio‘s feel. Each tension is set by a different

machine screw.

3. Reconnect transmitter battery pack and reinstall radio back

cover and cover screws.

4.3.5 Throttle stick travel adjustment

The throttle stick travel is adjustable to suit your flying style.

1. Switch off the transmitter and remove the 8 screws that secure the

radio back cover. Next, remove the radio back cover. Be sure to

disconnect the transmitter battery pack connector.

2. Use indicated machine adjustment screws to limit the throttle

stick travel. By turning the screw clockwise, you will shorten the

throttle stick travel.

3. Reconnect transmitter battery pack and reinstall radio back cover

and cover screws.

After making a limit change to the throttle stick travel you must

recalibrate the transmitter stick in the software menu, see section

–Calibration of Proportional Controls.