CONFIDENTIAL RF Module Installation Manual JETCO Model JTR-01 JETCO Model JTR-01 RF Module Installation Manual JTR-01 RF Module - Installation Manual.
CONFIDENTIAL RF Module Installation Manual JETCO Model JTR-01 February 27, 2019 Contents Overview ...................................................................................................................................................... 1 Image: Base Station and RF Modules ....................................................................................................... 1 Labeling Requirements, Warnings, and Notices ........................................................................
CONFIDENTIAL RF Module Installation Manual JETCO Model JTR-01 February 27, 2019 Overview This document contains installation instructions for JETCO JTR-01 RF modules. JETCO JTR-01 RF modules can be used to form a simple wireless connection for devices that typically connect directly to a computer through a USB port configured as virtual serial COM port. The modules support a ASCII based serial protocol with carriage return terminated messages.
CONFIDENTIAL RF Module Installation Manual JETCO Model JTR-01 February 27, 2019 Labeling Requirements, Warnings, and Notices If a JTR-01 module is placed within a separate enclosure: the following label must be placed on the outside of the enclosure: Contains Transmitter Module FCC ID: 2ASF5-JTR01 No modifications may be made to the JTR-01 module: WARNING: This module must be used as received from the manufacturer.
CONFIDENTIAL RF Module Installation Manual JETCO Model JTR-01 February 27, 2019 Required Materials - One JETCO JTR-01 module factory configured as a Base Station (Model number JTR01-B). The Base Station module requires: - One, 5V DC power supply (Globtek, WR9HA2000CCPMFR6B) - One, USB Male A to USB micro B female cable. - One, or more, JETCO JTR-01 RF modules in the normal RF Module configuration. (Model number JTR-01-R). - One, Windows 10 based computer with a USB 2.0, or higher version, port.
CONFIDENTIAL RF Module Installation Manual JETCO Model JTR-01 February 27, 2019 5. If the Base Station responds as above, it is set up correctly. If it doesn’t respond, check that the power supply is connected and has AC power and that the USB cable is correctly connected. Repeat steps 1 through 5.
CONFIDENTIAL RF Module Installation Manual JETCO Model JTR-01 February 27, 2019 RF Module Setup Connect the RF Module to the serial device it’s meant to communicate with. The device must supply 3.3V to 5V power, at a minimum of 200 ma, to the RF module through the USB port and serially communicate through the USB port at 115,200 baud. The device must support messages that are entirely ASCII and are terminated by the ASCII carriage return character. JTR-01 RF Module - Installation Manual.
CONFIDENTIAL RF Module Installation Manual JETCO Model JTR-01 February 27, 2019 Serial Protocol The overall serial protocol derives from the device that is connected to an RF module. All serial protocols are permitted as long as they support the following structure: - Baud Rate: 115,200 baud. (RF Module requirement only. May change with new versions) ASCII characters only. Each message is terminated by a carriage return. CR = 0x0d.
CONFIDENTIAL RF Module Installation Manual JETCO Model JTR-01 February 27, 2019 Serial RF Module Configuration Base Station modules are configured at the factory and there are no user configurations available. RF Modules are configured at the factory to use two character or nine character addresses. If nine character addressing is configured, there are no user configurations available.
CONFIDENTIAL RF Module Installation Manual JETCO Model JTR-01 February 27, 2019 Company Contact JETCO Torque Tools LLC 835 Meridian St. Duarte, CA 91010 Phone: (626) 359-2881 Email: TBD Document Version Version Changes Released Released Date 1.00 Initial REM 2019-02-26 1.01 Added allowable maximum antenna gain REM 2019-02-27 JTR-01 RF Module - Installation Manual.