Operating Instructions and Parts Manual DSLT-770 Double Scissor Lift Table For serial no. 17020001 and higher JET 427 New Sanford Road LaVergne, Tennessee 37086 Ph.: 800-274-6848 www.jettools.com Part No.
Warranty and Service JET® warrants every product it sells against manufacturers’ defects. If one of our tools needs service or repair, please contact Technical Service by calling 1-800-274-6846, 8AM to 5PM CST, Monday through Friday. Warranty Period The general warranty lasts for the time period specified in the literature included with your product or on the official JET branded website. • JET products carry a limited warranty which varies in duration based upon the product.
Table of Contents Warranty and Service ............................................................................................................................................ 2 Table of Contents .................................................................................................................................................. 3 Introduction ......................................................................................................................................................
Introduction This manual is provided by JET, covering the safe operation and maintenance procedures for a JET Model DSLT-770 Double Scissor Lift Table. This manual contains instructions on installation, safety precautions, general operating procedures, maintenance instructions and parts breakdown. This machine has been designed and constructed to provide consistent, long-term operation if used in accordance with instructions set forth in this manual.
Assembly 1. Attach the handle (A, Figure 1) to the frame using two hex cap bolts, two lock washers, and two flat washers. Tighten with a 19mm wrench. Note: The two rear casters can be locked so that they do not rotate. Press foot lever (B, Figure 1) 2. Attach foot lever (A, Figure 2) to the lever bracket (B, Figure 2) with one hex cap screw, one flat washer, and one lock washer (C, Figure 2). Tighten with a 14mm wrench. Keep hands and feet clear of table and scissor lift openings while lowering load.
Maintenance 1. Lubricate each friction point monthly with #2 tube grease. 2. Check the movement and wear of wheels. 3. Check for oil leakage from the hydraulic cylinder. 4. Store with table in lowered position. Troubleshooting DSLT-770 Double Scissor Lift Items in parentheses refer to the index numbers in the parts breakdown. Trouble Probable Cause Remedy Oil level low in hydraulic pump. Remove air breather (9) and fill with hydraulic fluid.
Parts Breakdown for DSLT-770 Double Scissor Lift Table 7
Parts List for DSLT-770 Double Scissor Lift Table Index No. Part No. Description Size Qty 1 ................ DSL770-01G ............. Table ........................................................................ ...................................... 1 2 ................ DSL770-06 ................ Link Shaft ................................................................. ...................................... 2 3 ................ DLS770-02 ................ Link Assembly...............................
Index No. Part No. Description Size Qty [26] ............ SB-5MM .................... Steel Ball.................................................................. Ø 5 mm ......................... 1 [27] ............ SLT660F-36-25 ......... Spring ...................................................................... ...................................... 1 [28] ............ SLT660F-36-26 ......... O-Ring* .................................................................... Ø 10 x 1.9 mm ..............
Index No. Part No. Description Size Qty 73 .............. SLT660FH-78............ Swivel Wheel Assembly (index # 20-25, 28, 31, 32) 1 .................. DSL770-RK ............... Repair Kit ................................................................. ...................................... 1 Index numbers with brackets [ ] are part of the Hydraulic Pump Assembly, DSLT770H-35. Parts included in the Repair Kit are indicated by an asterisk *.
This page intentionally left blank.
427 New Sanford Road LaVergne, Tennessee 37086 Phone: 800-274-6848 www.jettools.