ACTIVE RSE MONITOR‐10.
English ATM1010AA0 Owners Manual English 2012 Atom Enterprises, Inc. All rights reserved. This manual, or any portion thereof, may not be reproduced without the express written consent of Atom Enterprises, Inc. For any questions, please call customer service (855) 574‐2866 www.atomenterprisesinc.
English ATM1010AA0 Owners Manual Table of Contents General information 4 Safety instructions 4 General Characteristics 4 Cleaning and care 4 Supported media 5 Country codes 5 Opening and closing display 6 Front panel control buttons 7 Inputs/outputs 8 Remote control 9‐10 Wireless IR headphones 11 Operation Playing a disc 12 Playing media via A/V input 12 Playing media via USB 12 Playing media via HDMI/MHL input 12 FM Transmitter function 12 Sharing media between monitors 13 Setup System setup menu 13 DVD s
General Characteristics Please read this instruction manual carefully. •10.1” LED LCD display •1024 x 600 Resolution •Slot load DVD player •Front sensor key pad controls •Support IR headphones/remote control •Analog A/V input‐1/8” Jack •USB 2.0/1amp charging •SD card slot •Stereo headphone output‐1/8” Jack •FM Transmitter (88.3‐107.7 MHZ) Poor road conditions can cause problems with some media playback. In cold environments, the screen may sometimes display distortion. This is normal.
Region Countries in this region Supported disc media 1 Canada, USA, US territories 2 Japan, Europe, South Africa, Middle East (including Egypt) 3 South East Asia, East Asia (including Hong Kong) 4 Australia, New Zealand, Pacific Islands, Central America, Mexico, South America, Carribean 5 Former Soviet Union, (also North Korea, Mongolia), Indian subcontinent, Africa 6 China Before inserting media, ensure that it is compatible with the system.
Opening and closing the display English Display is held closed with 2 flexible tabs that snap into the sides of the display. Pull on the tabs outward to disengage the tabs before opening the display. The display can then be opened and viewing angle adjusted by rotating it into the upright position (see below) Caution: Please make sure tabs are snapped fully into the display when in the closed position to make sure the display is secured safely.
English Panel Control Buttons/Disc slot 7 6 8 1 1. 2. 3. 4. 5. 6. 7. 8. 2 3 4 5 Power button‐turns system power on/off. Source button‐select media source for playing media (ie:DVD, AV input, MHL/HDMI, USB, SD) Play‐starts playing media source selected. Pause‐pauses media that is playing. Stop‐stops media that is playing. Eject‐ejects disc (display MUST be in closed position to insert/eject disc) Disc slot (ONLY ACCESSIBLE WHEN DISPLAY IS CLOSED) Monitor identification‐ “A” OR “B”.
English Inputs/Outputs 3 1 4 2 5 1. 2. 3. 4. 5. HDMI input (MHL compatible) USB 2.0 input (1 amp charging) Headphone jack output (wired) A/V input jack (analog 3.
Remote Control Buttons/Functions To control monitor A, press the A button first. To control monitor B, press the B button first. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 1. POWER ‐ turns power on/off 2. UP ‐ navigate selection up 3. LEFT ‐ navigate selection left 4. ENTER ‐ accepts selection 5. FM ‐ turns FM transmitter on/off (station can also be changed when button is depressed) **Function is for Monitor A only. 6. PLAY ‐ select to play media 7. REVERSE ‐ reverses play (fast) 8.
English Remote Control Battery Installation/Operation TAB 1. 2. 3. Remove battery cover by depressing tab (in direction of arrow) then lifting cover. Insert 2 AAA batteries (make sure batteries are installed with correct polarity (+/‐) Reinstall battery cover ! NOTE: There is risk of fire if batteries are not handled correctly. Do NOT recharge batteries. Do NOT intermix different battery types, or batteries not charged the same amount. Please dispose of batteries per local laws.
Wireless Headphones Headphones are dual channel (A and B channel) infrared wireless. Channel must be selected to match the display monitor being viewed (see below) Headphones must be in line of sight of display monitor to receive audio signal Headphones require (2) AAA batteries. NOTE: Please make sure volume control is set to low for the safety of the next user (excessive volume can cause permanent damage) Please note: headphones will power off automatically if no audio is played for more than 3 minutes.
Operating Instructions Turning power on Turn vehicle ignition “ON/ACC”. Press power button on RSE front panel or remote control. Playing a Disc Close display and insert disc (label side facing towards you) Open display (AFTER DISC IS FULLY INSERTED) Make sure DVD –Disc is the selected source. Press play to start media. NOTE: disc can only be ejected when display is in closed position. Playing media from USB Insert USB device into USB slot on left side of unit. Make sure DVD‐USB is the selected source.
Sharing media on monitor B from monitor A 1.Press output source button on monitor A. 2. Use the up/down navigation buttons or output source button to scroll through sources (DVD‐disc, DVD‐ SD, etc) 3. Select source desired to be viewed on monitor B. 4. Press the source button on monitor B. 5. Use the up/down navigation buttons or source button to scroll through the sources available until monitor A is highlighted. 6. Select monitor A. NOTE: media can only be shared from monitor A to monitor B.
FCC declaration Unit will not power on This system complies with FCC directive, section 15. System is subject to the following 2 conditions: 1.This system must not cause any harmful interference 2.This system may be subject to interference which may cause unwanted operation. 1.Be sure vehicle is turned on Remote control not working 1.Check batteries for correct installation and make sure they have plenty of charge left. 2.
English Canada IC This Class B digital apparatus complies with Canadian ICES‐003. This device complies with Industry Canada license‐exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. This device and its antenna(s) must not be co‐located or operation in conjunction with any other antenna or transmitter.
Panel size 10.1” Resolution 1024 x 600 Backlight LED Ratio 16:9 Luminance 500 NIT (typ.) Expected backlight life 20k hours Min. Operation temperature ‐20~70 degrees C Storage temperature ‐30~80 degrees C Video display system NTSC Input voltage 10‐16VDC I/O ports USB 2.0, HDMI, SD, 3.5mm AV, 3.5mm earphone IR Channels A monitor: 2.3/2.8mhz B monitor: 3.2/3.
Spanish ATM1010AA0 Owners Manual Spanish 17
French ATM1010AA0 Owners Manual French 18