2.4GHz WIRELESS Plug-In AV SENDER OWNER’S MANUAL (PLEASE READ BEFORE USE) PATENT TX JESMAY ELECTRONICS CO., LTD ROOM 1004, STANHOPE HOUSE 738 KING’S ROAD, QUARRY BAY, Hong Kong TEL: (852) 2563 4292, 2562 6212 FAX: (852) 2565 7026, 2516 9417 E-mail: info@jesmay.com.hk Web Site: http://www.jesmay.com.
■ Important-Safety Precautions This device of which operation is subject to the following two conditions (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. • To prevent fire or shock hazard, do not expose this device to rain or moisture. Do not use near a bathtub, washbowl, kitchen sink, or laundry tub, in a wet basement, or near a swimming pool.
B. Introduction to 2.4GHz Wireless Plug In AV SENDER This sender system is a wireless audio/video sender that uses advanced wireless communication technology to deliver consistently sharp audio and video up to 100 meters away. By transmitting at a very high frequency (2.4 GHz), it avoids the crowded 900 MHz band used by many cordless telephones and other wireless audio/video transmitters. It’s superior quality is due to wide-band FM rather than AM signal modulation.
FRONT VIEW FOR TRANSMITTER Front VIEW FOR RECEIVER Power indicator Channel select CH3 or CH4 (NTSC only) Power indicator Power on/off switch Power on/off switch RF output to TV (e.g.2058R) DC power input connect to power adapter (7.5V DC) DC power input connect to power adapter (7.5V DC) IR extender port IR extender mouse (emitter sensor) emits infrared signals and control the source A/V equipment.
D. Setting Up 2.4GHz wireless Plug-In AV SENDER To enjoy wireless video and audio, just plug the transmitter into whatever A/V source you want to enjoy from another location, and plug the receiver in the TV, monitor or powered speakers in that other location. Application: 1. Installation: ROOM 1 ROOM 2 Desktop 42" TFT Monitor TX Make sure the ON/OFF switch is in the cOFF f position before connection. ■ How To Transmit Audio/Video signal from Your VCR or DVD or SAT etc. 1.
■ How To Receive Wireless Audio/Video Signals on Your TV or monitor 1. Just plug into the RCA or SCART output port of TV or Monitor. If you use receiver with RCA plugs the yellow, red and white plugs have to match the yellow, red and white port of TV or Monitor 2. Plug one end of the power adapter into the back of the transmitter and the other end into any 230-volt wall outlet (or 120-volt). Note: use only the adapter provided. Note1: You can use T type scart adapter jesmay Model No.
E. Troubleshooting, Care and maintenance Please read this owner's manual carefully and follow the steps described in it. If you still have difficulties, consult the following table. It will guide you though the most common problems and their solutions. Problem No picture or sound Interference: Noisy picture or audio Remote control extender does not work Possible solutions • Check if plug the transmitter and receiver tightly into A/V sources and display equipment.